2003 isuzu ascender

need wire diagram to install a remote start and keyless i think its the same as a trailblazer the keyless part is the colors i need and factory diarm thanx any1

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        | |              12V|red (x2)           |+ |ignition harness            | |          STARTER|yellow              |+ |ignition harness            | |        IGNITION|pink               |+ |ignition harness            | | SECOND IGNITION|white               |+ |ignition harness            | |        ACCESSORY|orange              |+ |ignition harness            | | SECOND ACCESSORY|brown               |+ |ignition harness            | |       POWER LOCK|use Directed module |   |                            | |     POWER UNLOCK|part #455G *3       |   |                            | |       LOCK MOTOR|gray               |   |driver door module in door | |     UNLOCK MOTOR|tan                 |   |driver door module in door | |    DISARM DEFEAT|tan                 |   |relay box under rear seat   | | PARKING LIGHTS +|brown               |   |driver kick panel           | | PARKING LIGHTS -|gray/black          |   |headlight switch            | |       HEADLIGHTS|white               |- |headlight switch            | |     DOOR TRIGGER|gray/black          |+ |underdash lt or dri A pillar| | DOME SUPERVISION|comes on with disarm|   |                            | | TRUNK/HATCH PIN|pink/black *1       |- |liftgate module             | |        HOOD PIN|pink/black          |- |pin switch or BCM           | | FCTRY ALARM ARM|                    |   |                            | |FCTRY ALRM DISARM|lt. green           |- |driver door module in door | |       TACHOMETER|white               |   |blue plug, pin 49 @ PCM *2 | |      SPEED SENSE|GREEN / WHITE        |   |blue plug, pin 32 @ PCM *2 | |       BRAKE WIRE|white               |+ |brake pedal switch          | |     HORN TRIGGER|black or blk/yel    |- |steering column             | |           WIPERS|                    |   |                            | | LF WINDOW UP/DN|blue - brown        |A |driver door module          | | RF WINDOW UP/DN|lt. blue - tan      |A |front passenger door module | | LR WINDOW UP/DN|blue - brown        |A |LR window switch            | | RR WINDOW UP/DN|blue - brown        |A |RR window switch            | | SUN RF OPN/CLOSE|blue/red - blue     |A |sun roof motor              | |        RADIO 12V|orange              |+ |radio                      | |     RADIO GROUND|BLACK/ white        |- |radio                      | |     RADIO SWITCH|                    |   |                            | | RADIO ILLUMINATE|BROWN / white (dimmer)|+ |radio                      | |    POWER ANTENNA|gray               |+ |radio                      | |       LF SPEAKER|tan - gray          |   |radio                      | |       RF SPEAKER|lt. green - green   |   |radio                      | |       LR SPEAKER|brown - yellow      |   |radio                      | |       RR SPEAKER|blue - lt. blue     |   |radio                      | Notes: NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use DEI part 555L. *1 The liftgate glass ajar switch wire is purple. It is also located at the liftgate module in the liftgate. *2 The PCM (Powertrain Control Module) is on the driver side of the motor. *3 If Directed module part #455G is not available, refer to directfax document #1053.

thanx for the diagram but how do i get the lock & unlock mod and will it work with crimestopper remote start

You can get the mod at any shop that carries DEI products suck as viper, python, etc. they ususally run around $40 and yes it will work with your system.

$60 for the 455G and $40 for the 555L