astroflex wiring

Home / the12volt's Install Bay / Car Security and Convenience / astroflex wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

loneranger

Copper - Posts: 572

Joined: December 28, 2008

Posted: March 10, 2009 at 3:53 PM / IP Logged

waym wrote:

There are 2 - 12 volt constant available in the ignition harness, a red and RED / black wire. How would I know which 12V feeds which loads?.

Dis-connect the harness from the switch and test for continuity, at the switch. The vehicle wiring was designed by automotive-electrical engineers for a reason. Follow their design. It's not anal retentive. It's best practice. astroflex wiring - Page 2 -- posted image.

Ideal - cmon dude, add to topics in a useful manner, not stuff that is obvious.

Story - Phzzzt! Hey, what happened?! ... Isn't it obvious?

Moral - Never dismiss the obvious.

waym

Member - Posts: 8

Joined: March 06, 2009

Location: Alberta, Canada

Posted: March 10, 2009 at 5:31 PM / IP Logged

Initially I wasn't planning on doing the install myself but with your guidance so far I am getting more confident to attempt it. I did a little more research and found out the vehical had a computer controlled transmission. Will this affect the install as far as making sure all the ignition points are connected. I noticed that on this site, the vehical wiring table shows an extra ignition connection compared to the chart posted by loneranger. Can anyone confirm.

loneranger

Copper - Posts: 572

Joined: December 28, 2008

Posted: March 10, 2009 at 6:36 PM / IP Logged

waym wrote:

.. I noticed that on this site, the vehical wiring table shows an extra ignition connection ..

Here is the other wiring schematic. As always, test for clarity.

Battery	LIGHT GREEN/ VIOLET	(+)	OR RED IGNITION SWITCH HARNESS
Ignition 1	WHITE/ YELLOW	(+)	IGNITION SWITCH HARNESS
Ignition 2	VIOLET/ORANGE	(+)	IGNITION SWITCH
Ignition 3	YELLOW
Accessory 1	BLACK/ LIGHT GREEN	(+)	IGNITION SWITCH HARNESS
Starter 1	GREEN	(+)	IGNITION SWITCH HARNESS

Ideal - cmon dude, add to topics in a useful manner, not stuff that is obvious.

Story - Phzzzt! Hey, what happened?! ... Isn't it obvious?

Moral - Never dismiss the obvious.

waym

Member - Posts: 8

Joined: March 06, 2009

Location: Alberta, Canada

Posted: March 12, 2009 at 11:01 AM / IP Logged

I found a factory ignition wiring diagram and it confirms that there is no ignition 3 connection. The chart on this site is not correct for my vehical.

loneranger

Copper - Posts: 572

Joined: December 28, 2008

Posted: March 12, 2009 at 11:08 AM / IP Logged

The first one I posted should be correct.

Ideal - cmon dude, add to topics in a useful manner, not stuff that is obvious.

Story - Phzzzt! Hey, what happened?! ... Isn't it obvious?

Moral - Never dismiss the obvious.

waym

Member - Posts: 8

Joined: March 06, 2009

Location: Alberta, Canada

Posted: March 12, 2009 at 10:17 PM / IP Logged

Yup, I believe your correct Loneranger. I'm gonna attempt the install this weekend, wish me luck. Thanks everyone.

waym

Member - Posts: 8

Joined: March 06, 2009

Location: Alberta, Canada

Posted: April 05, 2009 at 11:16 PM / IP Logged

I finally got this astroflex hooked up. The problems I am having now are several things, when the vehical remote start, there is a short delay then the dash instruments light up, the ABS light stays on and then the vehical shuts down and starts again. It does this 3 times. I also noticed that the astroflex module makes a clicking noise ( sounds like the relay in the module) when I use the key to start. It clicks for a little while then stops. Could I these weird things happen if I was missing another ignition connection? Just to confirm, the connection from the PATS 1 should go to the P2 connector dark green wire?.

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

astroflex wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.