wireless control electric motor fwd/rev

Can you post either a photo or a layout diagram of the back of the switch and I'll show you how.Test before boxing up.

Here is the original paper for harness. HTH dlm ny coutry

Well I had another light go on..in my head of course. To use the Spal switch all I need is to remove the ground from the harness (it runs parallel with other window switch) and feed ground to middle switch which normally gets ground. This way the switch is not resting at ground..I knew I should not have inhaled in High School.. has has dlm ny country

That all works fine…minus I loose my switch illumination light. If I could break the ground normal in the switch that goes to the top right connector in the diagram I could get my illumination back.. dlm ny country

I was going to tell you to remove the 12v+ and grounds, insert a ground in the centre tap but you'll lose your illumination. Back to square one.Test before boxing up.

Hi Harry. Well after getting some knowledge on relays (thanks) I found a good cheap device that will give me what I need on the windows,eliminate the relays and let me use the Spal harness as configured from factory. Autoloc WC1000 I got for $20.00 and it gives me remote use and one touch down. NO relays need. YEaH !! Doug M ny country