the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

wiring remote start + dei alarm 8th civic


Post ReplyPost New Topic
< Prev Topic Next Topic >
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: June 15, 2014 at 4:54 PM / IP Logged  
Test for defrost with a DMM one of those wires will either go POS or NEG when you push the button with the engine on.
Time to find a friend with a diagnostic reset tool.
verbstyler 
Member - Posts: 37
Member spacespace
Joined: June 07, 2014
Location: North Carolina, United States
Posted: June 15, 2014 at 5:42 PM / IP Logged  
What is this diagnostic tool that you speak of?
Because that may mean Stealership or Discount Tire for me.
I did do a quick google search for "remote start caused TPMS" and did find some stuff for various GM vehicles, but nothing for honda. Someone on some form mentioned that the TPMS is supposedly related to the Single Wire CAN in some way therefore it doesn't like DB-ALL being there.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: June 15, 2014 at 5:49 PM / IP Logged  
Nope it's unrelated to the DB-ALL, I've fitted DB-ALL and DB-ALL2 with no problems there, maybe the fault occurred when you connected the DB-ALL to the wrong plug.
verbstyler 
Member - Posts: 37
Member spacespace
Joined: June 07, 2014
Location: North Carolina, United States
Posted: June 15, 2014 at 5:50 PM / IP Logged  
This is my question about adding another sensor. The brain has two ports. One port has the external shock sensor + glass break sensor.
There is one more available port where I would like to add a tilt sensor below.
wiring remote start + dei alarm 8th civic - Page 5 -- posted image.
wiring remote start + dei alarm 8th civic - Page 5 -- posted image.
My further question is, are these sensor active (plug and play) ?
In the viper alarm i installed w/o remote start it was so, just had to adjust them. I wasnt sure if i need to go into some menu to "activate" them.
verbstyler 
Member - Posts: 37
Member spacespace
Joined: June 07, 2014
Location: North Carolina, United States
Posted: June 15, 2014 at 5:54 PM / IP Logged  
Are we just talking about a TPMS reset tool of some sort?
I bet you the my tire place probably has one, they install TPMS sensors...so i would hope they had one.
Otherwise ... dealer.
Im surprised theres not some "hard reset" way of doing this.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: June 15, 2014 at 5:58 PM / IP Logged  
Tilt sensor; cut off alarm side plug,orange to orange GWA wire (H1) on Viper, blue to blue instant trigger,(H2) on Viper red to red (H1) on Viper.
Your making a great big amateur mistake of too many sensors, loads of false alarms; personally I'd go for a second set of locking wheel nuts cheaper and more effective.
And yes an OBD ll reset tool.
Incidentally I cut both loops on the sensor, decreases false alarms.
verbstyler 
Member - Posts: 37
Member spacespace
Joined: June 07, 2014
Location: North Carolina, United States
Posted: June 15, 2014 at 6:05 PM / IP Logged  
I do have locking wheel nuts, but maybe i wont do the tilt sensor then.
I though I could just get the second sensor port to work.
verbstyler 
Member - Posts: 37
Member spacespace
Joined: June 07, 2014
Location: North Carolina, United States
Posted: June 15, 2014 at 6:07 PM / IP Logged  
Just wanted to say "Thanks" for the very extensive support once again !
I will report with results later about the defroster.
It may not be until next weekend though. We'll see if i have time during the work week. I work 9-5, usually pretty tired afterwards :)
verbstyler 
Member - Posts: 37
Member spacespace
Joined: June 07, 2014
Location: North Carolina, United States
Posted: June 18, 2014 at 11:29 PM / IP Logged  
So check out my findings.
I have not actually tested anything yet.
Didn't get around to it.
But i did find a diagram of the circuit.
And all of the 3 brown wires actually show up just as they do on the plug itself.
1 is far from the other 2. This is so on the actual plug and the diagram. So im guessing its going to be one of the two that are right above each other on the plug. Seems kind of stupid to have all of those wires be the same colors....sigh....will report back.
wiring remote start + dei alarm 8th civic - Page 5 -- posted image.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: June 19, 2014 at 1:54 AM / IP Logged  
Bottom right BRN.
Page of 7

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer