new to alarm viper 5904

Hello, I need help installing my viper 5904 into my recent project a 1979 Chevrolet malibu I have downloaded and printed wiring diagram for the vehicle and installation Manual for the alarm from this website. I have partial of the alarm installed, only part I need help on is the remote start wires. If anybody is willing to do step by step with me I would greatly appreciate it.. thanks in advance

Is there a specific question you have regarding the wires? I don't have a spare '79 Malibu layin around. No question is stupid or not worth asking. You were once a noob, right? :)

Oh yea im sorry to post which wires ill post them asap

H3/1 PINK (+) IGNITION 1 INPUT/OUTPUT H3/2 RED / WHITE (87) FLEX RELAY +12V INPUT (30A FUSED) H3/3 ORANGE (+) ACCESSORY OUTPUT H3/4 VIOLET (+) STARTER OUTPUT (CAR SIDE OF THE STARTER KILL) H3/5 GREEN (+) STARTER INPUT (KEY SIDE OF THE STARTER KILL) H3/6 RED IGNITION 1 +12V INPUT (30A FUSED) H3/7 PINK/WHITE (30) FLEX RELAY OUTPUT (car side of ign, acc or starter wire) H3/8 PINK/BLACK (87a) FLEX RELAY INPUT (key side of ign, acc or starter wire if needed) H3/9 RED / BLACK ACCESSORY/STARTER RELAY +12V INPUT (30A FUSED) H3/10 NC No Connection CAR IGNITION HARNESS Constant 12V+ Red Ignition Switch Harness Starter Purple Ignition Switch Harness Ignition Pink Ignition Switch Harness Accessory Orange Ignition Switch Harness Tach White Coil Brake Switch White Brake Switch Trunk Pin n/a     Parking Lights Dark Brown Light Switch Hood Pin n/a     Factory Disarm n/a     Door Trigger White (-) Driver's Pin Switch Door Lock Light Blue Driver's Kick Panel Door Unlock Black Positive Trigger Horn Wire Black (-) Steering Column

You've actually posted the answer so what's the problem? H3 Red H3 RED / White H3 RED / black ALL to Red constant at ignition harness. H3 Pink to Pink at ignition harness H3 Orange to car Orange ditto Cut Purple from ignition harness, H3 Green to key side, H3 Purple to starter motor side H3 Pink/white, Pink/black not used. Install a hood pin provided from a safety angle, you don't want the R/S to start up with someone (you?) working in the engine bay.

Where do I connect H3/2 RED / white?

H2 Violet white to white at coil. H2 Brown to brake switch white (switched side, goes live when you brake). H2 Grey. Hood pin. H2 Blue.Trunk pin, if the factory uses a tilt switch in the light fitting you need to solder between the switch and the bulb terminal. H1 White. Parking lights set fuse on unit to NEG (see reference chart in the box)to brown. H2 green door trigger white. H2 BROWN / black to black horn wire. Use a 451 module or a pair of relays for the locks, green to light blue, blue to black.

Ohh nvm lol got it

Answered.

Thanks Howie. I didn't understand where H3-2/7/8/9 would go but u answered them thanks , ill get to it in the A.M.