the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

re audio xtx500.5 amp in protection mode


Post ReplyPost New Topic
< Prev Topic Next Topic >
still_walkin 
Silver - Posts: 644
Silver spacespace
Joined: April 18, 2007
Location: California, United States
Posted: September 02, 2014 at 9:56 PM / IP Logged  
So I have a re audio amp and the subs terminals got crossed while it was on and out the amp In protection mode. So I turned the amp off and turned it back on and still five minutes later same thing there is no fuse on the amp and the main power wire fuse should be working because I have leds and a cig charger on the same power wire . Suggestions or im set back on a amp
1993 sdv
Alpine 4x6 6x9 5 1/4 swr-10d4
alpine v60
12.5 VGA flip down
Nettop pc w/10" touch screen
78nova
5-re audio 5x7 ,10" sub &
Xtx-500.5
"Take the faceplate off get the jumperpack"
tonanzith 
Gold - Posts: 593
Gold spaceThis member consistently provides reliable informationspace
Joined: July 18, 2008
Location: Washington, United States
Posted: September 03, 2014 at 9:47 PM / IP Logged  
Check you ground and voltage at the amp with the sub wires disconnected. If your ground is good and you have over 12 volts to the remote and power wires than the amps shot. I stress check actual voltage and not just use a test light. I have seen MANY times where the main power wire fused near the battery is not completely blown. Especially glass fuses. It starts to blow and only allows 6v or so through. Enough to light a test light and allow an amp to power up but not enough to allow power output.
Gary Sather
still_walkin 
Silver - Posts: 644
Silver spacespace
Joined: April 18, 2007
Location: California, United States
Posted: September 03, 2014 at 9:52 PM / IP Logged  
Sad part is I know better I'm usually on the other side preaching. Well amp shopping I go. If it cost more than the amp to fix I'm just buy a new one
1993 sdv
Alpine 4x6 6x9 5 1/4 swr-10d4
alpine v60
12.5 VGA flip down
Nettop pc w/10" touch screen
78nova
5-re audio 5x7 ,10" sub &
Xtx-500.5
"Take the faceplate off get the jumperpack"

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer