viper 4806v in automatic 2004 camry le

Yes I have followed that chain exactly. Each time I turn the ignition off and then hold button for 5 seconds, nothing happens. I cannot get into the programming menus at all.

Is the door open at the same time or the green grounded?

Yes I have tried it both ways. I understand that wire is the door trigger wire and it has to see ground during programming. I think this may be a problem with the key sense. In the camry there is a blue key sense (-) wire at the ignition. Do I have to hook any wires from the viper brain in order for the starter to work and get into programming? When I used a DMM to test the blue key sense wire in the camry it read 12V and when I insert the key into the ignition it reads 0V. Sorry Im not trying to be difficult or confusing. I appreciate all of the help you are giving me.

Yes I believe I mentioned it earlier, you'll need that to unlock the car via the Viper remotes when the engine is running, connect to either dark blue or blue/white (not WHITE/ blue) wires on H2 marked either status output or ground when running (GWR).

Hi Howie, I attached the dark blue status output to the key sense wire in the car. It did not do the trick. I still cannot get into programming to switch the car to automatic transmission mode.

Ok So I figured it out! The problem was in the control center button. The pin on the micro connector was not making contact with the button. I other words, the pin was bent. Its fixed, and I got into programming and everything works fine. Thanks everyone for the help. I really do appreciate it.

Is that the new shape antenna? I haven't met one yet in the UK but I've heard that the plugs are a PITA!

I don't know if it is new shape but the unit was manufactured in August 2014 so it is pretty new. In my research, a lot of people have been running into this problem.

We had 2 or 3 over here in England some months ago, still waiting for new control centres and /or antenna leads!

Hello hasr I have exact problem, installed 4806v into automatic Sentra 2007, in conjunction with DBall2. Parking light blinks 7 times when trying to remote start. I understand I need to reprogram the 4806v to work with automatic transmission. Can you please provide instructions/steps/manual for making the programming change? Have been searching but have not found it yet. It would be very much appreciated.ttok