compustar keeps running the starter motor

andrewiffic wrote: So I checked continuity and got the following: 010 between starter and ign1 004 between starter and ign2 600 between starter and acc Are those values too low for ign1 and ign2? I'm not sure what to do about that.

I'm not sure what measurement those values are and if they are taken from the switch with the connector unplugged. You didn't answer the question of whether the remote start functions properly with the ignition switch disconnected.

Alright the problem has been fixed. Sorry to waste all your time. 2 problems: I had to isolate the starter wire using a relay. And I had the wrong starter wire. Doh. Apparently I can't follow a wire through a connector when I'm upside down under the steering wheel and the wires all change colour at the connector. The correct starter wire goes from a thin guage red wire on one side to a thick BROWN / red wire on the other side. I incorrectly traced it to a thick WHITE/ black right next to it that tested up the same. Needless to say, my bad! Thanks for the suggestions, I still wouldn't have figured out how to isolate the starter wire without your tips. It works properly now.