92 jeep wrangler, viper 5806v

hello guys. im installing a viper 5806v into a jeep wrangler 4.0. All i care about is the remote start.I hooked up the 12v constant, starter,ignition, access, parking lights, tach and brake wires. Couple questions... 1-When i hit the remote start on the remote it beeps and does nothing. Paper says to hold the control center button after 5 seconds of starting the car and the light will turn on to learn the tach. The light will not turn on but it will flash when i hit the unlock and lock buttons. 2- Manual says i need to hook up pin 15 - door input and pin 18 + door input for manual cars. This jeep has one wire to the door. Where do i catch these wires? Will this have any affect on the remote start not working? 3-nuetral safety switch says it needs to be grounded for a auto and hooked up to parking brake for manual. My clutch is bypassed so can i just ground this wire? 4-Is there any wire that needs to be connected to the clutch wire? I see nothing on any of the pinouts for a manual. If anyone has any input please feel free to type it below or even text me 9543286166. Any help is appreciated. Thanks.

I checked for voltage to the starter both sides when hitting the r s button. I get nothing on either side. I do not have the neutral safety switch, doors, or trunk wires connected if That matters. I can not program the control center for the tach also. I must be missing something. Driving me insane...

These are the charts in writing off of. Thanks..

Sorry about the double.

Join the green H2 wire to ground.

This one is complete. THanks