the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

no output on igntion 1 h3/1


Post ReplyPost New Topic
< Prev Topic Next Topic >
freqsounds 
Copper - Posts: 289
Copper spacespace
Joined: October 17, 2008
Location: Virginia, United States
Posted: December 19, 2014 at 6:58 PM / IP Logged  
howie ll wrote:
Have you powered up H3 red, RED / white and RED / black to a constant 12V+ source?
Piggybacking!
This was going to be my next guess.
All 3 of those source wires have fused 30A fuses. I've seen some harnesses where the fuses don't make good contact with the terminals inside the fuse holders.
If you're using pink/white, make sure the feature 3.8 is set to "Ignition 2" not "Accessory" or "Starter"
No question is stupid or not worth asking. You were once a noob, right? :)
Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer