remote start 2010 honda crv

Hello all, what a awesome forum this is! Okay, installing a remote start on a 2010 Honda CRV and using a Dball2 and Avital 4103LX all in D2D. From the preliminary research, it looks like a very easy install (easier than my last job 05 Grand Caravan). On the dball2 type 2 instructions, I get this odd note saying this about the lock/unlock outputs: So here's my question, is it as simple as what they say? I was under the impression that the output on the dball 12 pin connector only had a 500ma output, which isn't much. Do I go on blind faith and connect the wires as they say, or do I install isolation relays? Thanks in advance for any advice

No relays required. The door locks in the car are low current negative trigger.sparky

bingo, the wires in that you're tagging will operate the relay in the vehicle. Look in the pictorials for the 2007 civic. The cars are almost identical.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert