dball2 flash settings

Hello all! I'm looking to flash my DBall2 for my 2006 4Runner SR5 without an OEM alarm. I'm using it with a Viper 4706V and a 529T for my back window. My main purpose for it is to be used as an immobilizer bypass. Are there any other settings I need to have checked/on when I flash it? Like the door locks, SS, ST, RS settings...? Or can I just uncheck them all since it's just being used as an immobilizer bypass...? Thanks! Nick

The trick is to flash it once with ALL the settings deleted, then a second time picking the settings you want. You might have to repeat this a few times.

Dang good to know! Thanks Howie II. I flashed with all of them unchecked and now need help figuring out which to check before i flash it again. Below is a list of what I think I need to get the remote start working properly, the door locks, and my 529T for my back window to roll up and down. Any corrections I need to make? DL-Lock CHECKED DL-Unlock CHECKED DL-Trunk RS-Request engine coolant temp. RS-Request vehicule speed RS-Request intake air temperature (outside temp) RS-Request RPM CHECKED RS-Ground when running CHECKED RS-Start command CHECKED RS-Stop from remote CHECKED RS-Starter CHECKED RS-Ignition command RS-Acc from RS RS-Ignition from RS RS-Dome light from RS RS-Aux1 CHECKED RS-Aux2 RS-Aux3 RS-Aux4 RS-Chirp RS-Car finder RS-Parking light activation ST-Hand brake ST-Hood ST-Trunk ST-Driver door ST-Other doors ST-Brake ST-Key sense CHECKED ST-Ignition ST-Glow plug ST-Park Neutral OEM Keyless-disarm OEM Keyless-arm Hidden ST-OBDCAN SS-Alert Status SS-OEM Alarm RS-Request Runtime CHECKED Nick

just flash it as default no need to make changes, as the bypass is only good for transponder override. You should have bought a pkall or key-override-all. Cheaper and does the same job. This car is dated prior to the can network. Analogue connections are required.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert