2001 pontiac grand am SE Wiring Diagram

Can someone please provide me with a wiring diagram to install a remote start in a 2001 pontiac grand am SE. thank you!

2001-2002 PONTIAC GRAND AM ITEM | WIRE COLOR               |POL| WIRE LOCATION 12V|red                          |+ |ignition harness *1 STARTER|yellow                   |+ |ignition harness *1 IGNITION|pink                    |+ |ignition harness *1 SECOND IGNITION|dk. green        |+ |ignition harness *1 ACCESSORY|orange                 |+ |ignition harness *1 SECOND ACCESSORY|brown           |+ |ignition harness *1 POWER LOCK|white                 |- |drivers kick panel in POWER UNLOCK|same wire           |*2 |a black plug DISARM DEFEAT|tan               |- |passenger kick panel PARKING LIGHTS +|brown           |+ |passenger kick or column HEADLIGHTS|dk. blue & pink       |*3 |steering column DOOR TRIGGER|*4                  |- |*4 DOME SUPERVISION|white           |- |dash light or column TRUNK/HATCH PIN|ORANGE / black     |- |trunk light TRNK/HTCH RELEASE|BLACK/ white    |+ |drivers kick panel TACHOMETER|white or PURPLE / wht   |- |ignition coil or ECM *5 SPEED SENSE|dk.GREEN / WHITE       |- |ECM *5 BRAKE WIRE|lt. blue              |+ |at the switch HORN TRIGGER|black               |- |steering column WIPERS|dk. grn & purple          |+ |steering column LF WINDOW UP/DN|dk. blue - gray     |A |drivers door switch RF WINDOW UP/DN|lt. blue - tan      |A |drivers door switch or kick LR WINDOW UP/DN|dk. green - pur/wht |A |drivers door switch or kick RR WINDOW UP/DN|lt. green - purple |A |drivers door switch or kick SUN RF OPN/CLOSE|blue - green       |A |sunroof motor RADIO 12V|orange                 |+ |at radio RADIO SWITCH|yellow              |+ |at radio LF SPEAKER|tan - gray            |   |at radio or LF speaker RF SPEAKER|lt. grn - dk. grn     |   |at radio or RF speaker LR SPEAKER|brown - yellow        |   |at radio or LR speaker RR SPEAKER|dk. blu - lt. blu     |   |at radio or RR speaker Note: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with a RESISTOR GM PASSLOCK BYPASS MODULE. *1 Remove the radio, without unplugging it, to access the ignition harness. *2 Lock requires a negative trigger, and unlock requires a negative trigger door lock system through a 1,500 ohm resistor. Must use relays. Must close doors to lock with a single pulse. *3 Requires a high current ground. Use a relay. *4 The lt. GREEN/ black is located in the drivers kick and catches only the drivers door. The lt. blue is located in the harness coming from the drivers running board going under the drivers seat and it catches all other doors. Use both door trigger wires and diode isolate each. On the 2 door the lt.blue is in the passenger kick. *5 The ECM is located under the left side of the dash to the left of the column.

i am doing a remote start on a 01' Pontiac Grand Am SE using the crimestopper rs900 model. I never worked on a GM that has the Passlock II. Im not quite sure what i need to do to disable this during a remote start attempt?I did not start this yet. the crimestopper does have a wire that says it should be hooked up to the oem disarm wire. Is this all i will need or do i need to buy another device to disable that?and if so does this wire just get connected to the tan wire the diagram shows as disarm defeat?