2004 Nissan Titan Alarm/Remote Start Wiring

I was wondering if anyone had the wiring diagram for remote start and aftermarket security system or where i can get it... Thanks....

DIRECTWIRE™ WIRING INFORMATION - NISSAN / TITAN / 2004 / Remote Start [PRINT THIS PAGE] 12volts      green (40A)       +       ignition harness Starter      brown       +       ignition harness Second Starter      lt. green or blue/green       +       ignition harness Ignition      BLACK/ red       +       ignition harness Second Ignition      N/A             Third Ignition      N/A             Accessory      red       +       ignition harness Second Accessory      purple       +       ignition harness Keysense      RED / blue to BLACK/ red       +       ign harn or BCM R of column, pin 37 Power Lock      blue       -       driver door module in door Power Unlock      red (double pulse)       -       driver door module in door Lock Motor      purple       5wi      BCM to right of column, pin 65 Unlock Motor      green       5wi      BCM to right of column, pin 59 Parking Lights+      RED / blue       +       dimmer switch on dash Parking Lights-      N/A             Hazards      WHITE/ black       -       BCM to right of column, pin 29 Turn Signal(L)      GREEN/ black       +       BCM to right of column, pin 60 Turn Signal(R)      GREEN/ YELLOW       +       BCM to right of column, pin 61 Reverse Light      GREEN / WHITE       +       inside rearview mirror Door Trigger      see notes       -       BCM to right of column Notes: The LF door trigger is lt. blue in pin 47. The RF door trigger is RED / blue in pin 12. The LR door trigger is RED / yellow in pin 48. The RR door trigger is RED / white or gray in pin 13. Use all four wires and diode isolate each. Dome Supervision      blue       -       BCM to right of column, pin 63 Notes: The blue wire is for the dome lights and puddle lights. For the step lights use RED / white in pin 62 at the BCM. Trunk/Hatch Pin      N/A             Hood Pin      N/A             Trunk/Hatch Release      N/A             Power Sliding Door      N/A             Factory Alarm Arm      arms with lock             Factory Alarm Disarm      disarms with unlock             Disarm No Unlock      single pulse power unlock wire            Tachometer      NOT WHITE/ blue or black       ac       any ignition coil Wait to start      N/A             Brake Wire      RED / green or RED / black       +       brake pedal switch Parking Brake      green       -       parking brake switch or cluster Horn Trigger      RED / white       -       horn switch Memory Seat 1      lt. GREEN/ black       -       memory mod. left of column, pin 9 Memory Seat 2      pink/blue       -       memory mod. left of column, pin 25 Memory Seat 3      N/A       -       Immobilizer Bypass Module:      Required: Yes      Type: Transponder      Part #: 556U or 555U Notes: N/A        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.

thank you, i appreciate it, is there place to get the wiring diagrams for 2000 and newer so i don't have to bug you guys

easy truck. Do a search on the Armada/QX56 in the carsound.com security forum, and you'll find a few tricks, including doorlocks inside the truck.