99 honda accord ex alarm/remote start

i have a 99 accord ex sedan that Im going to put an autopage rs720 in...i was looking through the car and looking for the wires that are on the wiring diagram here but some dont seem to match, or im not looking in the right spot...but i was wondering if anyone knew of anoither wiring schematic i could use or where to get one????Don't hop it...Bodydrop it

Constant 12 volts	WHITE	IGNITION SWITCH HARNESS
Ignition 12 volts	BLACK / YELLOW	IGNITION SWITCH HARNESS
Starter	BLACK/ WHITE	IGNITION SWITCH AHRNESS *
Dome Light	BLACK/ WHITE (-)	4 PIN CONN. IN PASSENGER FUSE BLOCK
Trunk Pin Switch	ORANGE (-)	18 PIN CONN. IN DRIVER KICK PANEL
Parking Lamp	RED / BLACK (+)	GREEN 20 PIN CONN. DRIVER FUSE BLOCK
Power Lock	BLACK/ WHITE	2 PIN GRAY CONNECTOR IN
Power Unlock	GREEN/ RED	DRIVER KICK PANEL (LX MODEL) **

* Installing A Starter Kill Relay At The Ignition Switch Harness Before The Starter Wire Enters The Driver Side Fuse Block May Cause A "Check Engine" Light To Come On. Starter Wire Should Be Accessed After Fuse Block. **EX Model Access Door Locks At Passengers Side Multiplex 20 Pin GREEN Con Unlock BLU/ORN (-) Pin 4 Lock BLACK/ ORANGE(-)Pin 16.Behind Lower Cover.  Negative Pulse Door Locks

Accessories
Window Up	D\ RED / YEL P\ BLU/WHT RED / BLU P\ RED / BLU @ EACH SWITCH*
Window Down	F/ RED / BLU F/ BLU/YEL R/ RED / YEL R/ RED / YEL *
Ign Key Warn	BLUE/WHITE (-)	IGNITION SWITCH HARNESS
Trunk Release	GRN/BLU (-) AT KEYLESS	MODULE (LX), WHT/RED (+)(EX)****
OEM Horn	LIGHT GREEN/ BLUE (-)	STEERING COLUMN HARNESS **
Headlights	BLUE/RED (-)	HEADLIGHT SWITCH
OEM Alarm Arm		SEE TECH ON IGNITION DISABLE
OEM Alarm Disarm	ORANGE (-)	BEHIND GLOVE BOX IN 24 PIN CONNECTOR

* Due To Multiplexing Window Wires Must Be Accessed At Each Window Switch But All Are Reverse Rest At Ground Type Circuits. ** Horn Wire Can Also Be Found At GREEN 16pin Connector AT Passenger Fuse Box. *** Disarm Can Be Found As BLUE (-) At Driver Multiplex Unit (Door Switch). **** Located At Pass Multiplex Control Unit Behind Right Side Glove Box. 

Reversal Rest At Ground Window Circuit

Remote Start
Tach Signal	BLUE	WHT 2 PIN TEST CONN-PASS REAR ENGINE*
Ignition #2	YELLOW	IGNITION SWITCH HARNESS
Ignition #3	N/A
Accessory	WHITE/ BLACK	IGNITION SWITCH HARNESS
Neutral Safety	BLUE/WHITE (-)	GREEN 20 PIN CONN DRIVER FUSE BLOCK
Brake Light	WHITE/ BLACK (+)	SWITCH ABOVE BRAKE PEDAL
Reverse Light	GREEN/ BLACK (+)	GREEN 10 PIN CONN DRIVER FUSE BLOCK
Rear Window Defrost	BROWN / YELLOW (-)	REAR DEFOGGER SWITCH

Immobilizer Bypass

. * 4 Cylinder Models- 6 Cylinder Models Connector Is On Driver Rear Of Engine EX Model- RKE Built Into Passenger Multiplex Unit

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

DIRECTWIRE™ WIRING INFORMATION - HONDA / ACCORD / 1999 / Remote Start 12volts white   +   ignition harness Starter BLACK/ white   +   ignition harness Notes: If doing starter kill, must interrupt the wire between the keyswitch and the fusebox, not between the fusebox and the starter, to keep the check engine light from coming on. Second Starter N/A        Ignition BLACK / YELLOW   +   ignition harness Second Ignition N/A        Third Ignition N/A        Accessory yellow   +   ignition harness Second Accessory WHITE/ black   +   ignition harness Keysense           Power Lock BLACK/ blue   -   passenger side fuse box Notes: in a green 20 pin connector. Use BLACK/ white for lock and GREEN/ red for unlock on LX models without factory security. These wires are located in a two pin gray connector by the front of the drivers side fuse box. Power Unlock orange   -   passenger side fuse box Notes: in a green 20 pin connector. Use BLACK/ white for lock and GREEN/ red for unlock on LX models without factory security. These wires are located in a two pin gray connector by the front of the drivers side fuse box. Lock Motor WHITE/ red      driver side fuse box Unlock Motor        driver side fuse box Notes: yellow on the EX and lt. GREEN/ red on the LX Parking Lights+ RED / black      driver side fuse box Parking Lights- RED / yellow      steering column Notes: Only available on the EX model. Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light GREEN/ black   +   driver side fuse box Door Trigger BLACK/ white   -   passenger side fuse box Notes: In a green 4 pin connector. Dome Supervision use door trigger        Trunk/Hatch Pin orange   -   drivers kick panel Notes: Above the hood release in a gray 18 pin connector. On the DX & LX models, also found in a 2 pin connector behind the drivers fuse box. Hood Pin yellow/red or yellow   -   hood pin switch or Notes: On the EX models it is in a green plug next to the passenger side fuse box. On the LX models it is at the keyless/security unit, if equipped, which is attached to the driver side underdash panel. Trunk/Hatch Release WHITE/ red   +   drivers kick panel Power Sliding Door           Factory Alarm Arm           Notes: Arms and disarms with the door locks on the EX models. The LX models arm only with the factory transmitter. Factory Alarm Disarm           Notes: Arms and disarms with the door locks on the EX models. The LX models arm only with the factory transmitter. Disarm No Unlock blue   -      Notes: On the EX the wire is located at the drivers power window switch, on the LX the wire is at the keyless/security unit which is attached to the drivers underdash panel. Tachometer blue      tach test connector Notes: The tach test connector is located behind the battery on the 4 cylinder, and on a bracket attached to the drivers side strut tower on the 6 cylinder motor. The tach test connector is a white 2 pin connector, and may be covered by a black rubber boot. Wait to start           Brake Wire WHITE/ black   +   brake pedal switch Parking Brake           Horn Trigger lt. GREEN/ blue   -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder Part #: 556HW Alternate Part1 #: 556UW Alternate Part2 #: 555H Alternate Part3 #: 555U Notes:        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.

thanks guys!Don't hop it...Bodydrop it

I just finished putting in the autopage 720 and I wired up the 555H but it doesnt seem to work....The LED comes on to show that it owrks but when you program the key the LED is supposed to go off but doesnt. I have tried my 2nd key but still the same problem.  Has any one had this prob, or know of a way to fix???Don't hop it...Bodydrop it

The 555H is pretty easy. Is it lighting up telling you that it learned the code? What wires did you grab do you have all the power connections?~The Rookie~

Rookie of the year that is...

Don't let the smoke out of your equiptment..it doesn't go back in.