03 outlander wiring

Anyone know where I can get wiring for this vehicle.

DIRECTWIRE™ WIRING INFORMATION - MITSUBISHI / OUTLANDER / 2003 / Remote Start 12volts blue/white (40A)   +   ignition harness Starter BLACK / YELLOW   +   ignition harness Second Starter N/A        Ignition blue/black   +   ignition harness Second Ignition N/A        Third Ignition N/A        Accessory blue/red   +   ignition harness Second Accessory blue / YELLOW   +   ignition harness Keysense RED / blue      ignition harness Notes: This wire rests at ground with the key out of the ignition cylinder, and goes to an open circuit when the key is inserted. Power Lock lt. GREEN/ red   -   ETACS ECU, pin 33 Notes: The ETACS ECU is attached to the back of the fuse box. Power Unlock BROWN / red   -   ETACS ECU, pin 34 Notes: The ETACS ECU is attached to the back of the fuse box. Lock Motor blue/black   5wi 28 pin plug above fuses, pin 19 Unlock Motor blue/white   5wi ETACS ECU, pin 22 Notes: The ETACS ECU is attached to the back of the fuse box. Parking Lights+ GREEN / WHITE   +   15 pin plug below fuses, pin 2 Parking Lights- N/A        Hazards green   -   ETACS ECU, pin 55 Notes: The ETACS ECU is attached to the back of the fuse box. Turn Signal(L) GREEN/ YELLOW   +   15 pin plug below fuses, pin 8 Turn Signal(R) GREEN/ red   +   15 pin plug below fuses, pin 13 Reverse Light RED / green   +   38 pin plug in driver kick, pin 8 Door Trigger brown   -   15 pin plug below fuses, pin 10 Dome Supervision red   -   3 pin plug below fuses, pin 1 Trunk/Hatch Pin common with door trigger wire        Hood Pin N/A        Trunk/Hatch Release N/A        Power Sliding Door N/A        Factory Alarm Arm lt. GREEN/ red   -   ETACS ECU, pin 42 Notes: Meter this wire while turning the key in the driver door key cylinder. The ETACS ECU is attached to the back of the fuse box. Factory Alarm Disarm BROWN / white   -   ETACS ECU, pin 25 Notes: Meter this wire while turning the key in the driver door key cylinder. The ETACS ECU is attached to the back of the fuse box. Disarm No Unlock see factory alarm disarm        Tachometer WHITE/ green   ac   engine speed detection connector Notes: The engine speed detection connector is a single pin connector in the fuse/relay box under the hood. Can also go to one of the ignition coils and use the BLACK/ blue or WHITE/ blue wire. Can also go to any fuel injector and use the wire that is NOT red. Wait to start N/A        Brake Wire blue/orange   +   brake pedal switch Parking Brake yellow   -   parking brake switch Horn Trigger lt. GREEN/ black   -   ETACS ECU, pin 44 Notes: The ETACS ECU is attached to the back of the fuse box. Memory Seat 1 N/A        Memory Seat 2 N/A        Memory Seat 3 N/A        Interface Module: Category: Immobilizer Bypass Required: No Type: N/A Part #: N/A Notes:        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.