the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2005 chrysler sebring sedan


Post ReplyPost New Topic
< Prev Topic Next Topic >
customconcepts 
Member - Posts: 3
Member spacespace
Joined: September 14, 2002
Location: United States
Posted: June 21, 2007 at 7:57 PM / IP Logged  
2005 chrysler sebring sedan - need wiring info - thanks for any help.
customconcepts 
Member - Posts: 3
Member spacespace
Joined: September 14, 2002
Location: United States
Posted: June 21, 2007 at 8:14 PM / IP Logged  
i am installing a remote start on a 2005 chrysler sebring sedan - looking for any help i can get. thanks
phonymike 
Member - Posts: 29
Member spacespace
Joined: June 20, 2007
Location: United States
Posted: June 21, 2007 at 9:17 PM / IP Logged  

https://www.the12volt.com/installbay/vehicles.html

there's info for a 2004, maybe it'll help.

KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: June 22, 2007 at 8:24 AM / IP Logged  
 PASSIVE ANTI-THEFT YES TRANSPONDER   SEE NOTES 
 12 VOLTS Pink/black Ignition switch harness   + 
 IGNITION Blue Ignition switch harness   + 
 IGNITION 2 Dk.GREEN/ red Ignition switch harness   + 
 ACCESSORY BLACK/ orange Ignition switch harness   + 
 ACCESSORY 2 BLACK/ white Ignition switch harness   + 
 STARTER Yellow Ignition switch harness   + 
 KEY SENSE Lt.blue Ignition switch harness   - 
 TACH SIGNAL SEE NOTES     
 The 2.7L engine has a coil per cylinder. Use the wire at any coil opposite from the DK.GREEN/ LT.GREEN. On the 2.4L, go to the coil pack and use the BLACK/ GRAY or the BLUE/TAN.
 FUEL INJECTOR Opposite from Dk.GREEN/ orange At any injector on engine   AC 
 LOCK WHITE/ dk.green Pin-15 on C4 connector at BCM   + 
 If vehicle has a factory alarm, use the arm/disarm wire for doorlock operation. This vehicle uses a 1-wire doorlock system with resistors. Use a 1780-ohm resistor to lock, and a 730-ohm resistor to unlock, both with a positive pulse. The C4 connector is located on the bottom of the Fusebox/BCM assembly under the driver's side dash.
 UNLOCK WHITE/ dk.green Pin-15 on C4 connector at BCM   + 
 If vehicle has a factory alarm, use the arm/disarm wire for doorlock operation. This vehicle uses a 1-wire doorlock system with resistors. Use a 1780-ohm resistor to lock, and a 730-ohm resistor to unlock, both with a positive pulse. The C4 connector is located on the bottom of the Fusebox/BCM assembly under the driver's side dash.
 DRIVER LOCK MOTOR ORANGE / black Pin-9 on C4 connector at BCM   + 
 The C4 connector is located on the bottom of the Fusebox/BCM assembly under the driver's side dash.
 DRIVER UNLOCK MOTOR Dk.blue/white Pin-13 on C4 connector at BCM   + 
 The C4 connector is located on the bottom of the Fusebox/BCM assembly under the driver's side dash.
 PASSENGER UNLOCK MOTOR Pink/black Pin-25 on C4 connector at BCM   + 
 The C4 connector is located on the bottom of the Fusebox/BCM assembly under the driver's side dash.
 DOORPIN SEE NOTES     
 Doors are independent. Driver's door is TAN, passenger door is TAN/RED, left rear is TAN/ORANGE and right rear is TAN / YELLOW. All these wires are located on the C4 connector on the bottom of the fusebox/BCM assembly under the driver's side dash.
 TRUNK PIN Tan/black Pin-18 on C4 connector at BCM   - 
 The C4 connector is located on the bottom of the Fusebox/BCM assembly under the driver's side dash.
 TRUNK RELEASE BLACK/ white At release switch in dash   - 
 FACTORY ARM Lt.GREEN/ orange Pin-4 on C4 connector at BCM   + 
 This vehicle uses a 1-wire system with resistors for arm and disarm. A 1800-ohm resistor will lock & arm, a 745-ohm resistor will disarm and unlock (double pulse). This wire works with a positive pulse.
 FACTORY DISARM Lt.GREEN/ orange Pin-4 on C4 connector at BCM   + 
 This vehicle uses a 1-wire system with resistors for arm and disarm. A 1800-ohm resistor will lock & arm, a 745-ohm resistor will disarm and unlock (double pulse). This wire works with a positive pulse.
 BRAKESWITCH WHITE/ tan At switch above brake pedal   + 
 PARKLIGHTS BLACK / YELLOW Pin-8 on brown 12-pin plug on back of fusebox   + 
 HAND BRAKE Gray/black Pin-6 on gray 16-pin plug on back of fusebox   - 
 HORN BLACK/ red At steering column   - 

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer