2010 Ford Edge Alarm/Remote Start Wiring

I am looking for remote start wiring for a 2010 Ford Edge.. Thanks.

This info from Bulldog Security

 EDGE   2009 -2010 

    PART                                                     COLOR                                   LOCATION  DIAGRAM  12 VOLT CONSTANT                          RED (+) 100AMPS         @ SMART JUNCTION BOX(BLACK 1-PIN PLUG(G) PIN 1, Note #2      STARTER                                             BLUE/WHITE (+)             @ IGNITION SWITCH HARNESS (BLACK 7-PIN PLUG) PIN 7      STARTER 2                                         N/A  N/A     IGNITION 1                                         WHITE/ ORANGE (+)        @ IGNITION SWITCH HARNESS (BLACK 7-PIN PLUG) PIN 1    IGNITION 2                                         N/A  N/A      IGNITION 3                                         N/A   N/A      ACCESSORY /HEATER BLOWER 1      PURPLE / GREEN (+)        @ IGNITION SWITCH HARNESS (BLACK 7-PIN PLUG) PIN 6      ACCESSORY /HEATER BLOWER 2      N/A   N/A      KEYSENSE                                       BLUE/GRAY (+)            @ IGNITION SWITCH HARNESS (BLACK 7-PIN PLUG) PIN 5      PARKING LIGHTS ( - )                    GRAY (-)                          @ HEADLIGHT SWITCH or SJB, (BLACK 52-PIN PLUG(B) PIN 31, Note #2      PARKING LIGHTS ( + )                  PURPLE / WHITE (+)        IN DRIVERS KICK PANEL or SJB, (BLACK 32-PIN PLUG(D) PIN 20, Note #2      POWER LOCK                               GRAY / YELLOW (-) TYPE (B)           IN DRIVERS KICK PANEL or SJB, (GRAY 26-PIN PLUG(C) PIN 17, Note #2      POWER UNLOCK                         PURPLE / GRAY (-) TYPE (B)            IN DRIVERS KICK PANEL or SJB, (GRAY 26-PIN PLUG(C) PIN 4, Note #2      LOCK MOTOR WIRE                    GRAY/BROWN (+) (Reverse Polarity 5-wire type)   IN DRIVERS KICK PANEL or SJB, (BLACK 32-PIN PLUG(D) PIN 6, Note #2      DOOR TRIGGER                             GRAY/VIOLET (+)          IN DRIVERS KICK PANEL      DOMELIGHT SUPERVISION          GRAY/PURPLE (+)        IN DRIVERS KICK PANEL or SJB, (GRAY 14-PIN PLUG(A) PIN 9, Note #2      TRUNK RELEASE                            BROWN (-)                   IN DRIVERS KICK PANEL or SJB, (GRAY 26-PIN PLUG(C) PIN 7, Note #2      SLIDING POWER DOOR               N/A   N/A      HORN                                                BLUE/WHITE (-)            @ HORN SWITCH or SJB, (BLACK 52-PIN PLUG(B) PIN 41, Note #2      TACH                                                 Any wire NOT BLUE      @ ANY FUEL INJECTOR      WAIT TO START LIGHT                  N/A   N/A      BRAKE                                              PURPLE / WHITE (+)       @ BRAKE SWITCH or SJB, (BLACK 52-PIN PLUG(B) PIN 40, Note #2      FACTORY ALARM DISARM           PURPLE / BROWN (-)       IN DRIVERS KICK PANEL or SJB, (GRAY 26-PIN PLUG(C) PIN 8, Note #2     ANTI-THEFT  TRANSPONDER ANTI-THEFT                      @ IGNITION SWITCH TUMBLER 

Note #2: The SJB (Smart Junction Box) is located under the Drivers side of the Dash.

Soldering is fun!

Does anyone know if the wires for the '10 are the same as the 2011 Edge? Also with the iDatalink ALCA work the the 2010 software in a 2011? any information will help.

Thanks

Mike

Mike

Are these the same wires?

 DOOR TRIGGER                             GRAY/VIOLET (+)          IN DRIVERS KICK PANEL    

 DOMELIGHT SUPERVISION          GRAY/PURPLE (+)        IN DRIVERS KICK PANEL or SJB, (GRAY 14-PIN PLUG(A) PIN 9, Note #2    

I installed an Autopage rs 1100 in the 2010 Ford Edge, everything works great except the trunk/hatch it opens just fine but if i hit the button again the relay clicks but wont close the trunk any ideas? Can anyone figure out how to display the temperature on the key fob the autopage manual is confusing as hell any info would be appreciated. ThanksMike