the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer

making a fiberglass mold of dash bezel

Display List of Forum Members Member List Forum Search Search Register Register Login Login
Post ReplyPost New Topic

< Prev Topic Next Topic >
unreal3z 
Member - Posts: 22
Member
Joined: April 23, 2004
Location: United States
Posted: April 25, 2011 at 7:29 PM / IP Logged  
I am looking to mold my ipad into my 2008 charger. But I want to keep my factory bezel intact for resale of the vehicle and just make a fiberglass mold of it to do my mods to. Can I simply tape it off, foil it, and glass over it and pull it off. Or is there a better approach?

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
  •  
Search the12volt.com
Custom Search
Follow the12volt.com Follow the12volt.com on Facebook
Monday, January 23, 2017 • Copyright © 1999-2017 the12volt.com Donate to the12volt.com Advertising Top of Page
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com - Free Installation Information for Mobile Electronics Installers, Enthusiasts, and Do-It-Yourselfers since 1999
Top
the12volt.com spacer
the12volt.com spacer