2012 Kia Sportage Remote Start Pictorial

sensor wire RX and TX are optional if mount the fuel sensor but I haven't it. I need only connect trigger door, ACC, siren and of course the power supply. But I don't know which are the wires ( trigger door, ACC ) I'm thinking don't use the relay to stop fuel pump because is dangerous. Please could you help me?

ACC Blue, Pin 2 6 pin plug at ignition. Doors:- GREEN/ orange Pin 10 white 54 pin plug at BCM above accelerator pedal. pink/black Pin 9 ditto yellow/black Pin 8 ditto grey/black Pin 17 ditto Hatch, white Pin 16 ditto. Hood/Bonnet RED / black Pin 18, white 24 pin plug also at BCM. Diode the door triggers together, 1N4004 diodes, bands away from alarm. Then diode each on hood and hatch same diodes and configuration. N.B. If this unit doesn't have separate triggers for trunk and hood, again throw it away and get a Cobra 3193 if still available, best ever Italian alarm and bullet proof. Or get a Viper 1002 with 508d for extra protection, will give you the same as the Cobra but also hatch release and more reliability than any Italian product.

Thank you howie II - ACC Blue, Pin 2 6 pin plug at ignition. A little summary door trigger is negative there is 4 trigger one for each door, pluged at BCM above accelerator pedal white 54 pin plug at BCM above accelerator pedal. : - GREEN/ orange Pin 10 - pink/black Pin 9 - yellow/black Pin 8 - grey/black Pin 17 Diode the door triggers together, 1N4004 diodes and - Hatch, white Pin 16 ditto - Hood/Bonnet RED / black Pin 18 in white 24 pin plug also at BCM. Is it correct? Thanks in advance.

BCM = Body Control Module On a modern car, usually Siemens or an inferior Marelli copy on Italian cars (yours is probably Siemens Denso)usually incorporated with the fuse box. Controls all interior functions from heat/AC to windows locks interior lights, hatch release wash/wipe etc. etc. Also called a multifunction module. Called a BSI (body systems integrator) on French cars. Look at the photos above for where it is, most of the wiring is there.

I understand, please do you confirm that there is one wire for each door trigger placed in white 54 pin plug at BCM above accelerator pedal? - GREEN/ orange Pin 10 - pink/black Pin 9 - yellow/black Pin 8 - grey/black Pin 17 Thanks

yes

I'll try to mount it and post my experience. Thanks a lot!

Sweet!When in doubt....kick it!

What kind of wire strippers are those, and are they decent down to 24 awg? my gardner bender and irwins tend to cut wires that small.Andrew Knoflicek

Inver Grove Toyota

What wire would turn on the defrost for the sportage? My new remote starter can go in defrost mode after car is started