python 574 and 507m tilt sensor

Invalid email address! Look for the install manual, Downloads/Manuals section, enter 507m.

Hello Howie! Thank you for looking into this, and to replying to this post. I ordered one from Amazon.com and it didn't ship yet. I don't understand your earlier response (about H2 and H1 harnesses). But I do want to utilize sensor 2 port on my 5706V alarm. How would I go about in doing so? Or would anyone know of the connector part number (from Mouser or Digikey) where I can build my own harness?

howie ll wrote: Took a photo but it didn't work, I'll email it to you now. THREE PIN PLUG!!! Unless they've changed it without telling us! No just checked the owners guide, tells you how good the local shop must be

It simply won't work in any of the sensor ports on your unit, different protocols so no point in approaching Mouser etc. for that plug. Again you have to hard wire it to red and orange on H1 and blue (via diode if already connecting blue to a trigger) on H2. If you don't understand what I mean by H1 and H2 you shouldn't be installing this yourself, RTFM, i.e. the referral sheet that comes in the 574 box.

Now, I understand, that the sensor 1 and sensor 2 ports use a different protocol. So the instant triggers that I can use is only door, hood, or trunk. Thanks,

howie ll wrote: It simply won't work in any of the sensor ports on your unit, different protocols so no point in approaching Mouser etc. for that plug. Again you have to hard wire it to red and orange on H1 and blue (via diode if already connecting blue to a trigger) on H2. If you don't understand what I mean by H1 and H2 you shouldn't be installing this yourself, RTFM, i.e. the referral sheet that comes in the 574 box.

Usually trunk or hood, doors aren't instant.