Viper 5704 Will Not Go Into Programming

You need to verify the ignition input is getting back to 5704 from the vehicle. H3/1 has to be hooked up in order to enter programming mode. Or use a Bitwriter to change the settings on the 5704.

Thanks. I hooked up the pink wire from the remote start harness which allowed me to access the control center programming. I programmed for automatic transmission and then started getting an 8 flash error. So, I grounded the BLACK/ white wire from the 24-pin harness (wire 13) and still got the error. I realized it was because the on/off switch was not connected to the alarm. I didn't connect it because the CHTDH2 harness for the dball2 also has the on/off switch along with the hood switch, so I figured I didn't have to connect the switch for the alarm. Now everything seems to be working. But, I am curious about the on/off switch for the dball2 CHTHD2 harness. What is that for? If I turn it on/off the remote start still works. Cheers!ajb

mraballard wrote: But, I am curious about the on/off switch for the dball2 CHTHD2 harness. What is that for? If I turn it on/off the remote start still works. Cheers!

Its for RSR installs on vehicles that already have OEM installed R/S. Too shutdown the DEI remotes from activating the OEM R/S VIA the DBALL/2/Pro.

Well I said everything seemed to be working fine, but that was before I actually got in to drive away. As soon as I let the emergency brake off, the car shuts down. I did ground the bkack/white on pin13 of the 24pin harness (h3?). Also, the alarm goes off after a short time if I remote start with the alarm active.ajb

Scratch that, it's not when I release the ebrake, it's when I put my foot on the brake pedal, the car shuts down.ajb

Try turning on the ignition when you enter the vehicle. If it's a PTS this may be the norm.