2010 ford edge and 535t

Home / the12volt's Install Bay / Car Security and Convenience / 2010 ford edge and 535t

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

spartaman10

Member - Posts: 1

Joined: February 15, 2014

Location: Ohio, United States

Posted: September 18, 2014 at 5:53 PM / IP Logged

Hello, I have a2010 Ford edge with Viper 5704. Tried to install 535t on front two windows. Passenger side goes fully up when armed, and vents via aux. The issue is the drive window. Looking for some help with the drive window due to the auto circuit. The driver window goes up a little bit on arm, and vents half of what passenger does via aux. I believe my problem is within the factory auto down circuit.. any help would be greatly appreciated. Thank you.

Back to Top

tonton1981

Member - Posts: 2

Joined: March 16, 2015

Location: Quebec, Canada

Posted: March 17, 2015 at 1:56 AM / IP Logged

your switch and motor wires are crossed at the 535t harness

example:

switch up side of door to switch down side of 535t

switch down side of door to switch up side of 535t

swap those around

do same for motor up/down wire

then try again

should be ok :)

Tony

Back to Top

xraytedrick

Member - Posts: 15

Joined: June 29, 2015

Location: New York, United States

Posted: June 30, 2015 at 12:56 PM / IP Logged

Hello, did you get this to work. If so, how? Thanks

Rick

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.