viper 4706, dball2, 2014 Ram w/tipstart

jimd2p wrote: I do have the XKLoader cable. I see where I have a mistake in the wiring. I have the Violet and not the pink going to the yellow/red of the t-harness. Off the t-harness I have everything plugged in accordingly and then the following: I'll change the yellow/red to the pink ORANGE / black to the violet pin 9 on the BCM F connector violet/brown to the WHITE/ brown pin 20 BCM G connector Not using the tach output. It shows a red from the remote starter going to Pin 3 of the BCM B. Which wire off the remote start should go here? As for the 4706 I have the following: H/1 to 12v constant H/2 to ground H3-H6 not used Door lock 3 pin connector not used 8 pin connector 1-4 to 12v constant Violet (not used)? Orange will be going to a window module later RED / white not used Pink to yellow/red of t-harness 24 pin 9-Hood pin 13-Ground Does this look right? Please let me know any suggestions. Again I thank you for taking your time to help me.

1) I will PM you my Xpresskit login so you can do the Key2Go. 2) correct the Pink wire to the Yellow/red. This connection is required for programming (ignition status) 3) You will make the Main harness connection H/1 to Pin3 of the BCM Connector B is a high current constant 12v source. Also connect Red of the remote start harness to the bcm. Now if it were my vehicle, i would use insulated female spades and Pin the pink ignition and red constant 12v-Only to reduce clutter. 4) Everything else looks good to me.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Thank you! I will try to make the connections changes this weekend. I appreciate you helping with the Key2Go!