I was told that the status wire was the ground when running wire i needed for the relay. The dball instructions didnt have it connected to the dball in d2d mode so I didn't connect it. I have the blue/white on the dball connected to the light green keysense wire on the ignition of the car so it will bypass when I use the key.
ok I will try again. these are the only wires i have connected. All other wires on the harnesses are not connected.
I am using this install manual: http://www.directeddealers.com/manuals/IG/Avital/N4103%202012-01%20web.pdf
and this wire guide for the car: https://www.the12volt.com/installbay/forum_posts.asp?tid=32838
So looking at the wiring connections starting on page 5 of the install guide going down.
---Main harness 9 pin connector:
brown horn output - black under the steering column
black ground - black chassis ground
---Door Lock 3 pin connector:
Not connected as I thought the DBALL would do the locks
---Heavy Gauge Relay 6 pin connector:
Pink output to primary ignition - pink ignition wire
Purple output to starter circuit - yellow starter wire
Orange output to accessory circuit - orange accessory wire
Red +30amp high current input - Red +12v (two of these)
Pink/White output to second ignition/accessory circuit -
Brown accessory wire (changed in firmware to accessory rather than ignition per the note on the vehicle wiring info sheet)
Since I do not have another ignition output for the green ignition wire from the remote starter I was told to use a relay. I have it connected as follows:
+12v red wire to 87, Pink ignition wire to 85, Green ignition wire to 30, blue status wire from satellite harness on remote start module to 86
I was told that the blue status wire was the "ground when running" I needed.
---Satellite harness 4 pin connector:
Blue status wire - 86 on 2nd ignition relay
---Remote start harness 5 pin connector:
BLACK/ white neutral safety switch input - Black Ground through provided toggle switch
Brown brake shutdown input - White brake wire
Of course I also have the antenna and programming button connected.