5806 Viper 2009 Pontiac G8 GT Issues

Installed a 5806v alarm remote start on my 09 G8 and having a few issues. One issues is that the remote start doesn't crank over, when remote started everything turns on such as accessory and gets ignition ready and then nothing. DBall2 is flashes with latest firmware. Followed wiring off Vipers manual to my vehicle. Also, when remote started the DBAll2 flashes green then red then orange I don't know what that means cant help to issue. Connections made Main Harness Red(Constant 12 Volts)---> Kick Panel Source Black(Chassis Ground)--->Ground Brown(Parking Light Isolation)--->NO Connection WHITE/ Brown(Siren)--->Connected White(Parking Light Output)--->DBAll2 Controlled Orange((-)500mA Ground When Armed)--->NO connection Remote Start Harness RED / Black((+)Fused 12V acc/starter input)--->Constant 12V at BCM Pink/Black(+)Flex relay input 87A)---> No connection Pink/White(+)Ignition 2/ Flex relay output)---> NO connection Red((+)Fused 12V ignition 1 input)---> org/red wire at BCM at Black Plug Green(+)Starter Input (key side)--->Dball2 controlled or the issue Violet(+)Starter Output(car side)--->Dball2 controlled or the issue Orange(+)Accessory Output)--->Brown wire at BCM Green Plug RED / White(+)Fused 12V ignition 2/ flex relay input 87)--->NO connection Pink(+)Ignition 1 input/ output)--->Pink wire at BCM green plug Aux Harness DBAll2 Controlled **** DBall2 controls starter crank I believe because G8 is Remote Start Ready Application. Dball2 Connections Gray/Black(+) Accessory output)--->Brown wire BCM Green plug GREEN/ Black(-)RAP off)--->My mistake connected wrong wire, will connected to driver door pin Light/Green(Single CAN Wire)--->OBDTHDGM1 harness Brown(12V)--->OBDTHGM1 harness Yellow(ignition)---> OBDTHGM1 harness