One diode for two window modules?

Home / the12volt's Install Bay / Car Security and Convenience / One diode for two window modules?

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

reelizmpro

Member - Posts: 14

Joined: April 16, 2006

Location: United States

Posted: June 09, 2016 at 12:13 AM / IP Logged

I am in the middle of installing two 535T window modules on my convertible. My Omega K9 alarm has a starter kill on the orange wire (ground when armed). I spliced into the orange wire and diode isolated (band facing alarm) the new wire. My question is can I run this isolated wire to both modules OR do i have to further isolate the modules from each other? I figure it should be fine since they are just accessories and not sensors that activate the alarm. Thanks.

Back to Top

reelizmpro

Member - Posts: 14

Joined: April 16, 2006

Location: United States

Posted: June 10, 2016 at 6:19 PM / IP Logged

Welp I figured it couldn't hurt to diode isolate everything so I went ahead and isolated the starter kill relay and the two 535T's with the stripes going toward the alarm.

I have a major problem...

The one touch UP/DOWN works perfectly but when I arm my alarm the windows roll DOWN instead of UP. The windows vent UP instead of DOWN. I checked my wiring and the one touch works right so it's not the window wiring. Any ideas?

Back to Top

reelizmpro

Member - Posts: 14

Joined: April 16, 2006

Location: United States

Posted: June 11, 2016 at 4:17 PM / IP Logged

Figured it out. I switched the GWA orange wire and the gray aux wire. Works perfectly now.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.