2013 Nissan Altima pts /aps 997 e

I figured once it's in data mode it locks out analog if hardwired . Either way I have to figure out why it's not programming . I'm pretty familiar with programming with prestige and can usually fly through it . I pushed the start button twice to turn ignition on to enter bank 1 which I know works cause I programmed remotes since I locked one out   and pushed 3 times to advance to next bank but there are no confirmation chirps . At that point I confirmed the ignition was on and it wouldn't advancebat9905

Try holding the Start button a little longer once in the "ON" position and see if it turns off. Otherwise you can use any temporary +12v source to get into programming modes with or with out a switch or alligator clip if you have one laying around. by applying power to the ignition input of the alarm, do this all the time when bench testing units.

Ok thanks . Good ideabat9905

No problem. Post back if the longer press in "ON" position worked to turn off the ignition or not.

That worked . I waited for about 3 seconds before cycling ignition on and off went into bank 3 . Thanks for your help . All is good . Surprised audiovox tech support didn't suggest that . Thanks againbat9905

That's what happens when you sit at a desk in front of a computer screen. You lose touch with the times.