CM7200 can't enter option programming

Home / the12volt's Install Bay / Car Security and Convenience / CM7200 can't enter option programming

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

schmooot

Member - Posts: 12

Joined: February 26, 2008

Posted: October 15, 2016 at 9:04 PM / IP Logged

Just installed into a 2004 Toyota Highlander. Have the CM7200 with a Prime 705 RF-2W705-SH 2 Way Remote Kit. I got the remotes to program alright but I can't seem to enter option programming mode.

WHat the manual states:

hold these two buttons for 3 seconds and then again to enter the table(wait for the chirp between steps) Then tap another button to scroll through (wait for the flash between steps) It should flash multiple times to tell me which line I am on while scrolling

What actually happens:

I hold the two buttons and the lights flash once, I hold them again and the lights flash once. Then I press the button to scroll and the lights flash once, I press the button again and the remote says error.

I'm assuming I am not getting all the way into the options table but the manual is vague.

Any insight is appreciated.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.