2012 Dodge Durango Alarm Wiring

I'm looking for alarm wiring or at least 12V constant and ignition for a 12 Durango. Thank you in advance!

DURANGO      2011-2013 KEY      T-HARNESS      IMMOBILIZER N/A      N/A      MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, SEE NOTE #1 PART      COLOR      LOCATION      DIAGRAM 12 VOLT CONSTANT      RED (+)      @ BATTERY or TIP Module, SEE NOTE #2       STARTER      NOT USED FOR REMOTE STARTING!            STARTER 2      N/A            IGNITION 1      PINK/WHITE (+) for IGNITION SENSE ONLY!!      @ WIRELESS IGNITION NODE, BLACK 12-PIN PLUG, PIN 3, at IGNITION SWITCH       IGNITION 2      N/A            IGNITION 3      N/A            ACCESSORY /HEATER BLOWER 1      N/A            ACCESSORY /HEATER BLOWER 2      N/A            KEYSENSE      N/A            PARKING LIGHTS ( - )      WHITE/ LT. GREEN (-) THRU a 1130 Ohm Resistor, use Relay to isolate Switch      @ HEADLIGHT SWITCH, BLACK 6-PIN PLUG, PIN 3       PARKING LIGHTS ( + )      WHITE/ BROWN (+) (L) & WHITE/ ORANGE (+) (R)      IN DRIVERS KICK, HARNESS to REAR of VEHICLE       POWER LOCK      PURPLE / LT.GREEN (-) THRU a 330 Ohm Resistor LOCKS      @ PASSENGER DOOR MODULE, BLACK 10-PIN PLUG, PIN 4       POWER UNLOCK      Smae wire, (-) THRU a 100 Ohm Resistor will UNLOCK            LOCK MOTOR WIRE      TAN/WHITE (5-WIRE TYPE)      IN DRIVERS KICK, at HARNESS to DOOR       DOOR TRIGGER      PURPLE (-)      IN DRIVERS KICK, at HARNESS to DOOR       DOMELIGHT SUPERVISION      YELLOW/WHITE (+)      IN DRIVERS KICK, HARNESS to REAR of VEHICLE       TRUNK RELEASE      PURPLE / TAN (-) THRU a 4700 Ohm Resistor      @ OVERHEAD CONSOL, 16-PIN PLUG, PIN 15       SLIDING POWER DOOR      N/A            HORN      GRAY / YELLOW(+)(HORN 1) and GRAY/LT.BLUE (+) (HORN 2)      @ HORNS or TIP Module, GREEN 26-PIN PLUG(C3), PINS 18 and 24, SEE NOTE #2       TACH      Any wire NOT BROWN / WHITE (AC)      @ Any FUEL-INJECTOR       WAIT TO START LIGHT      N/A            BRAKE      WHITE/ DK.GREEN (+)      @ BRAKE PEDAL SWITCH       FACTORY ALARM DISARM      N/A            ANTI-THEFT      MULTIPLEX IGNITION/ANTI-THEFT SYSTEM            NOTES NOTE #1: VEHICLE IS EQUIPPED WITH A TRANSPONDER/ MULTIPLEX IGNITION ANTI-THEFT SYSTEM AND REQUIRES AN INTERFACE MODULE PART #DBALL2 or XK09 FOR REMOTE STARTING. #2: The TIP Module is located in the ENGINE COMPARTMENT, on the PASSENGER Fender. ~wirewise~ Verify all wiring with your meter before making any connections!