mazda 2 car alarm wiring

i am having issues with my wifes mazda 2 .there is not much information about it ..well i have most of the wires connected ignition wise ...but i am stuck thinking does my mazda need a bypass for the remote car start..because i only have one key for this car ... also i am stuck on the door unlock and lock . i have opened up the door pannel at the switch i see 7 wires for the lock ???mateo

not sure if a relay is needed. i do know it is a type b locking systemmateo

MAZDA 2      2011-2014 KEY      T-HARNESS      IMMOBILIZER N/A      N/A      MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 PART      COLOR      LOCATION      DIAGRAM 12 VOLT CONSTANT      RED (+)      WHITE 6-PIN PLUG, PIN E @ IGNITION SWITCH       STARTER      BLACK/ BLUE (+)      WHITE 6-PIN PLUG, PIN C @ IGNITION SWITCH       STARTER 2      N/A            IGNITION 1      BLACK / YELLOW (+)      WHITE 6-PIN PLUG, PIN D @ IGNITION SWITCH       IGNITION 2      N/A            IGNITION 3      N/A            ACCESSORY /HEATER BLOWER 1      BLACK/ RED (+)      WHITE 6-PIN PLUG, PIN A @ IGNITION SWITCH       ACCESSORY /HEATER BLOWER 2      BLACK/ WHITE (+)      WHITE 6-PIN PLUG, PIN B @ IGNITION SWITCH       KEYSENSE      BLUE/BLACK (+)      WHITE 2-PIN PLUG, PIN B @ IGNITION KEY SWITCH       PARKING LIGHTS ( - )      BROWN / WHITE (-)      @ HEADLIGHT SWITCH or BCM, WHITE 24-PIN PLUG(E), PIN J, See NOTE #2       PARKING LIGHTS ( + )      GRAY/BLACK (+)      GRAY 16-PIN PLUG(C), PIN H @ BCM, See NOTE #2       POWER LOCK      PINK (-) TYPE B (1-WIRE SYSTEM)      DOOR LOCK SWITCH or GRAY 24-PIN PLUG(F), PIN P @ BCM, See NOTE #2       POWER UNLOCK      NEGATIVE PULSE THROUGH 1K OHM RESISTOR, SAME WIRE AS POWER LOCK            LOCK MOTOR WIRE      RED / BLUE (5-WIRE TYPE)      GRAY 16-PIN PLUG(C), PIN M @ BCM, See NOTE #2       DOOR TRIGGER      BLACK/ ORANGE (-)      GRAY 24-PIN PLUG(F), PIN I @ BCM, See NOTE #2       DOMELIGHT SUPERVISION      YELLOW/BLACK (-)      GRAY 16-PIN PLUG(C), PIN I @ BCM, See NOTE #2       TRUNK RELEASE      USE TRUNK RELEASE MOTOR!!            SLIDING POWER DOOR      N/A            HORN      PURPLE / RED (-)      @ HORN SWITCH or BCM, WHITE 16-PIN PLUG(B), PIN K, See NOTE #2       TACH      RED, RED / YELLOW, RED / BLACK or RED / WHITE (AC)      GRAY 2-PIN PLUG, PIN B @ ANY FUEL-INJECTOR       WAIT TO START LIGHT      N/A            BRAKE      GREEN/ YELLOW (+)      @ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, Harness to Rear of Vehicle       FACTORY ALARM DISARM      GREEN (-)      GRAY 24-PIN PLUG(F), PIN C @ BCM, See NOTE #2       ANTI-THEFT      MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1      @ IGNITION SWITCH TUMBLER       NOTES NOTE #1: This vehicle is with MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, for REMOTE STARTING ONLY you will need the Part #791 BYPASS Module and an Extra Ignition key. (Requires extra key for Operation) Part # PK-ALL or PKFM for REMOTE STARTING ONLY, requires 2 keys for programming, NO key required for Operation. Part # DB-ALL for Remote Starting and Keyless Entry operation (no resistors required), 2 keys required for programming, no key required for Operation. ================================================= MAZDA 2      2015-2016 KEY      T-HARNESS      IMMOBILIZER N/A      N/A      VEHICLES WITH SMART KEY AND PUSH TO START REQUIRES A DBALL2 INTERFACE FOR REMOTE STARTING PART      COLOR      LOCATION      DIAGRAM 12 VOLT CONSTANT      WHITE (+)      driver kick fuse box       STARTER      GRAY (+)      Start Stop Unit in steering column, white 24 pin plug, pin 23       STARTER 2      N/A            IGNITION 1      YELLOW (+)      Start Stop Unit in steering column, white 24 pin plug, pin 10       IGNITION 2      N/A            IGNITION 3      N/A            ACCESSORY /HEATER BLOWER 1      PINK (+)      Start Stop Unit in steering column, white 24 pin plug, pin 2       ACCESSORY /HEATER BLOWER 2      N/A            KEYSENSE      N/A            PARKING LIGHTS ( - )      PINK (-) USE HAZARDS      Start Stop Unit in steering column, white 32 pin plug, pin 4       PARKING LIGHTS ( + )      N/A            POWER LOCK      PINK(-) THRU 1000 ohms (ONE WIRE SYSTEM)      BCM above driver kick, white 32 pin plug, pin 6       POWER UNLOCK      SAME WIRE AS LOCK (-)      BCM above driver kick, white 32 pin plug, pin 6       LOCK MOTOR WIRE      TAN (5-WIRE)      ESU in driver kick, white 8 pin plug, pin 2       DOOR TRIGGER      GREEN (-)      BCM above driver kick, white 32 pin plug, pin 20       DOMELIGHT SUPERVISION      RED (-)      ESU in driver kick, white 18 pin plug, pin 16       TRUNK RELEASE      RED (-)      BCM above driver kick, white 32 pin plug, pin 10       SLIDING POWER DOOR      N/A            HORN      PINK (-)      horn switch, white 14 pin plg, pin 1 or BCM, white 24 pin plug, pin 22       TACH      BROWN (AC)      camshaft position sensor, engine driver side, gray 3 pin plug, pin 1       WAIT TO START LIGHT      N/A            BRAKE      BLUE (+)      Start Stop Unit in steering column, white 32 pin plug, pin 2       FACTORY ALARM DISARM      N/A            ANTI-THEFT      VEHICLES WITH SMART KEY AND PUSH TO START REQUIRES A DBALL2 INTERFACE FOR REMOTE STARTING~wirewise~ Verify all wiring with your meter before making any connections!

Thank you that helps me alot.. it looks like I need to get another key tho. Also do you have a pick or diagram of the door wiring with the 1 k ohm resistor? Not sure how to wire that up ?mateo

So I could set my car starter up to open my doors and trunk and bypass the remote starting of the car ? So basically use it for keyless entry ?mateo