2006 Subaru Legacy, CompuStar CS-800, ADS-AL-CA

I didn't know if I needed a relay or change the jumper when hooking up the blue wire! hooking blue wire from cm-800 to blue wire in ignition harness plug fixed the no heat, no ac, check engine light problem! for anyone else doing a 2006 legacy with cm-800 and ads-al-ca, here is the wirw's you need to hookup! lol a few wires not mentioned above that needs hooked up... factory alarm arm factory alarm disarm with these, the compustar remote obviously will not arm or disarm the factory security system and the alarm will go off if the alarm is armed (by factory key fob or locking doors with drivers door open) and you remote start your car. and the trunk release, if you want to use trunk release button on the compustar remote... I've read you need to "5 wire" it with a relay and it also has to connect to the disarm factory alarm wire or alarm wI'll go off when you open your trunk. I haven't made it this far, but I'll post an update when finished.