wiring my speakers, kicker comp r 12

Home / the12volt's Install Bay / Car Audio / wiring my speakers, kicker comp r 12

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

eakes_effect

Member - Posts: 1

Joined: May 17, 2017

Location: Tennessee, United States

Posted: May 17, 2017 at 7:21 PM / IP Logged

I recently purchased 2 kicker comp r 12 and I have a Sony xm-1652z amplifier. The specs on the amp are RMS Power: at 4 Ohms 1000 W x 2 RMS Power: at 2 Ohms 500 W x 2 Frequency Response: 5 Hz - 50000 Hz Signal to Noise Ratio: 100 dB THD at Rated RMS Power: 0.04 % Low - Pass Frequency: 80 Hz - 80 Hz MOSFET Circuitry: Yes Width: 16.69 in. Depth: 11.42 in. Height: 2.17 in. I was needing help with wiring them to get maximum power and efficiency. Currently I have them wired 4 ohm From looking on the kicker site. Any advice would be greatly appreciated. I do not have the amp bridged at this time.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.