the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Wiring Diagram for 2002 Chrysler Town and Country


Post ReplyPost New Topic
< Prev Topic Next Topic >
isaacl 
Member - Posts: 1
Member spacespace
Joined: June 29, 2002
Location: United States
Posted: June 29, 2002 at 10:50 PM / IP Logged  

All,

I am looking for a wiring diagram (for an new alarm install) for a 2002 Town and Country minivan.  Mainly concerned about the power door lock interface.  What is the best easiest way to control the power door locks.

Thanks,

Isaac

isaacl
Velocity Motors 
Moderator - Posts: 12,602
Moderator spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Electrical Theory. Click here for more info.spaceThis member has been recognized as an authority in Fabrication. Click here for more info.spaceThis member has been recognized as an authority in Mobile Audio and Video. Click here for more info.spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: March 08, 2002
Location: Manitoba, Canada
Posted: June 30, 2002 at 8:45 AM / IP Logged  

Chrysler

Town & Country

2002

Remote Starter  Wiring Colors and Notes

Function

 

Vehicle  Color

Location

Start:

 

YELLOW (READ NOTEs BELOW)

IGNITION SWITCH HARNESS *, **

Ignition  #1:

 

PINK/WHITE

IGNITION SWITCH HARNESS

Ignition #2:

 

N/A

Ignition  #3:

 

N/A

Accessory:

 

CHECK NOTES BELOW

Brake  Light:

 

WHITE/BLACK

AT SWITCH ABOVE BRAKE PEDAL

Tach  Signal:

 

See Notes

Parking Lights:

 

RED/BLACK (+)

AT GREEN PLUG NEAR FUSE PANEL ***

Headlights:

 

OEM Alarm  Disarm:

 

VIOLET/LT. BLUE

AT PLUG AT PCM ON FIREWALL DRIVER'S SIDE ***

OEM Alarm  Arm:

 

VIOLET/LT. BLUE

AT PLUG AT PCM ON FIREWALL DRIVER'S SIDE ***

Diesel  Glow Plug:

 

N/A

Clutch  Bypass Wire:

 

N/A

Notes:

 * Many Of These Vehicles Are Equipped With A Transponder (Even If The Key Is Black)** NOTE!!! A Second Start Wire (Purple/Brown) Needs Ground (-) Through A 180 Ohm Resistor Is Required For Remote Start. *** The parking lights are negative trigger thru a 2.1K ohm resistor. The headlights are negative trigger thru a 790 ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch.TACH SIGNAL: On the 2.4L use blue/green or blue/tan. On the 3.3L/3.8L use blue/green, blue/tan or blue/orange. ACCESSORY : RUNS WITH IGNITION & A diode must be placed inline on this wire to avoid problems with the dome lights and parking lights.

Chrysler

Town & Country

2002

Alarm and Keyless  Entry Wiring Colors and Notes

Function

 

Vehicle  Color

Location

Constant  +12 Volts:

 

RED

IGNITION SWITCH HARNESS (MAX 10 AMPS)

Starter  Kill:

 

YELLOW (READ NOTEs BELOW)

IGNITION SWITCH HARNESS *, **

Ignition  +12 Volts:

 

PINK/WHITE

IGNITION SWITCH HARNESS

Dome  Lights/Superv:

 

BLACK/WHITE (-)

AT 4 PIN PLUG NEAR FUSE PANEL

OEM Horn:

 

GREEN/BLACK (-)

STEERING COLUMN HARNESS

Power  Lock:

 

PURPLE/GREEN

AT PLUG AT PCM ON FIREWALL ****

Power  Unlock:

 

PURPLE/GREEN

AT PLUG AT PCM ON FIREWALL ****

Trunk  Release:

 

VIOLET/TAN

AT PLUG AT PCM ON FIREWALL DRIVER'S SIDE *****

Alarm  Input Wire:

 

BLACK/WHITE (-)

AT 4 PIN PLUG NEAR FUSE PANEL

Notes:

. Green Wire. If Equipped With A Factory Alarm, Use The Above Note. ***** A Single Pulse Of Ground Through A 2.2 K-Ohm Resistor Will Open The Liftgate. POWER SLIDING DOORS: Violet/Dk. Blue Wire At Switch. Driver's Side - A Single Pulse Of Ground Through A 2.7 K-Ohm Resistor. Passenger's Side - A Single Pulse Of Ground Through A 1.5 K-Ohm Resistor.
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
zorro33 
Member - Posts: 5
Member spacespace
Joined: December 04, 2002
Location: United States
Posted: December 07, 2002 at 4:47 AM / IP Logged  
please help me i try to instal an aftermarquer jensen cm715k and i cannot put power to the amp(infinity)original.please,please,tell me the cable connectio .i have97 town and country.i can use the cable blu of the antena,,but where i connect in the original truck plug??????

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, February 21, 2017 • Copyright © 1999-2017 the12volt.com Donate to the12volt.com Advertising Top of Page
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Donate to the12volt.com
Top
the12volt.com spacer
the12volt.com spacer