the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2004 Wrangler Alarm Info


Post ReplyPost New Topic
< Prev Topic Next Topic >
04Sahara 
Member - Posts: 12
Member spacespace
Joined: March 17, 2004
Posted: March 19, 2004 at 10:46 AM / IP Logged  

I'm installing a Clifford RSX 3.5 into a 2004 Wrangler Sahara with Sentry Key. Customer doesn't want auto-start at this time.

I need to know where the dome light/supervision wire is on the Jeep. 2003 info states to use the door trigger but I'm not too sure about that:

https://www.the12volt.com/installbay/forum_posts.asp?tid=15104&KW=wrangler

Customer also wants 524N (power door locks) and 508D (perimeter sensor) - any hints on placement? Customer either uses either soft top, no top, and doors off. Does not care about perimeter sensor when doors and hard top are on.

I searched and only found 2003 information and some of the wires seem to be a different color.

jfk51502003 
Copper - Posts: 221
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: March 26, 2004 at 4:23 PM / IP Logged  
12volts
2004 Wrangler Alarm Info -- posted image.
pink/black & red
2004 Wrangler Alarm Info -- posted image.
+
2004 Wrangler Alarm Info -- posted image.
ignition harness
Starteryellow + ignition harness  
Second StarterN/A    
Ignitionblue + ignition harness  
Second IgnitionN/A    
Third IgnitionN/A    
AccessoryBLACK/ orange + ignition harness  
Second AccessoryBLACK/ green + ignition harness  
Keysense    
Power Lock    
Power Unlock    
Lock Motor    
Unlock Motor    
Parking Lights+BLACK / YELLOW + headlight switch  
Parking Lights-    
Hazards    
Turn Signal(L)    
Turn Signal(R)    
Reverse Light    
Door Triggeryellow - headlight switch  
Dome Supervisionuse door trigger    
Trunk/Hatch Pin    
Hood Pin    
Trunk/Hatch Release    
Power Sliding DoorN/A    
Factory Alarm Arm    
Factory Alarm Disarm    
Disarm No Unlock    
Tachometergray ac ignition coil or coil pack  
Wait to startN/A    
Brake WireWHITE/ tan + brake pedal switch  
Parking Brake    
Horn TriggerRED / yellow - steering column  
Memory Seat 1    
Memory Seat 2    
Memory Seat 3   
rudbwoy69camaro 
Silver - Posts: 350
Silver spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: June 10, 2003
Location: United States
Posted: March 27, 2004 at 12:17 PM / IP Logged  
Well, seems that "jfk51502003" posted the wiring for a 2003....
pat231 
Member - Posts: 9
Member spacespace
Joined: June 13, 2003
Location: Canada
Posted: May 14, 2004 at 10:04 AM / IP Logged  
Battery 1 Pink/Black Ignition Harness Positive
Ignition 1 Blue Ignition Harness Positive
Starter 1 Yellow (2) Ignition Harness Positive
Accessory 1 BLACK/ Orange Ignition Harness Positive
Parklight Positive BLACK / YELLOW At Parking Light Switch Harness Positive
Brakes WHITE/ Tan At Parking Light Switch Harness Positive
Horn RED / Yellow At Sterring Collumn Negative
Tach Blue/Tan At ECM Passenger side Firewall Set 2 Cyl
E-Brake Gray/Black (5) Black Conn. Behind Instrument Cluster Negative
Clutch Bypass Yellow/Red At Clutch Switch Harness (3) Positive
OEM Hood Switch (1) At Hood Light Bulb Negative
F.L. Door Pin Tan Black Conn. Behind Instrument Cluster Negative
F.R. Door Pin Tan / YELLOW Black Conn. Behind Instrument Cluster Negative
Rear Deffoger Blue/White (4) Black Conn. Behind Instrument Cluster Negative
Head Light PURPLE / White At Parking Light Switch Harness Positive
Wiper Protection Pink/Black (6) At Wiper Switch Connector CUT
Back Up Light PURPLE / Black Driver's Kick Panel Positive
Comments :
Note:This vehicle may be equiped with a passive anti-theft system that uses a transponder use a OM-Chrysler-1 (P/N 310-907-514).
(1) You can solder a wire to the mercury switch under hood light assembly, it throws
a ground when the hood is opened and the light comes on.
(2) Starter Wire Yellow. For manuel remote starter installation connect the starter wire at the Yellow/Red at the clutch switch
(3) Connect the Remote Starter Wire directly on the Yellow/Red , for your " Clutch Bypass " instead of at the Ignition Switch.
(4) Rear Defrost Wire Blue/White. Need a 1 second negative pulse to trig it ON
(5) The E-Brake wire is Gray/Black at the E-Brake Switch, but it's Gray/White at the Cluster connector (See Picture)
(6) Wiper Cut Wire Pink/Black If the Wiper can operate durring the remote starter run time, use a relay to cut this wire with pin 30 and 87a and
one output program for << Ground While Running >>
Jeep Wrangler 2004

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer