the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2004 jeep Liberty alarm/remote start


Post ReplyPost New Topic
< Prev Topic Next Topic >
swamprat323 
Gold - Posts: 1,332
Gold spacespace
Joined: September 22, 2002
Location: Florida, United States
Posted: October 22, 2004 at 5:25 PM / IP Logged  
Need Alarm and RS info. Thanks
gpgtp00 
Copper - Posts: 85
Copper spacespace
Joined: April 11, 2002
Location: United States
Posted: November 21, 2004 at 1:47 PM / IP Logged  
yeah me 2. =) I need the alarm wiring info. Thanks
Bnluis 
Silver - Posts: 578
Silver spacespace
Joined: December 24, 2002
Location: New York, United States
Posted: November 21, 2004 at 1:56 PM / IP Logged  

LIBERTY 2004
WIRE COLORSLOCATION
12 VOLTS CONSTANTRED & PINK/BLACKIGNITION SWITCH HARNESS
IGNITION 1RED / DARK BLUE (+)IGNITION SWITCH HARNESS
IGNITION 2BLACK/ ORANGE (+)IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER BLACK/ WHITE (+)IGNITION SWITCH HARNESS
STARTERYELLOW (+)IGNITION SWITCH HARNESS
PARKING LIGHTS (+)DO NOT USE !!@ BLACK Plug, Back of FUSE BOX in the top left corner
PARKING LIGHTS (-)LIGHT GREEN/ ORANGE (-) @ HEADLIGHT SWITCH or BCM, GREY 22 Pin Plug Pin 5 See NOTE *3 *SEE DIAGRAM*
DOOR TRIGGERSee NOTE *2@ BCM, See NOTE *3
DOME LIGHTTAN (-)@ BCM, See NOTE *3
POWER DOOR LOCKPINK/PURPLE @ REAR of FUSE BOX, TOP LEFT Plug Pin 14
POWER DOOR UNLOCK1-Wire System same wire *SEE DIAGRAM*
TRUNK RELEASEORANGE / PINK (-)@ BCM, GREY 26 Pin plug Pin 17 See NOTE *3
TACH SENSORany wire NOT GREEN/ ORANGE or ORANGE / GREEN at any IGNITION COIL or FUEL-INJECTOR
BRAKEWHITE/ TAN(+)@ SWITCH ABOVE BRAKE
HORNBLACK/ RED (-)@ STEERING COLUMN HARNESS
FACTORY DISARMLIGHT GREEN/ ORANGE (-) See NOTE *4@ BCM, Connector 2, Pin 9 *SEE DIAGRAM*

NOTE *1 the PARKING LIGHTS turn on with a (-) Negative thru a 1000 Ohm resistor See DIAGRAM

NOTE *2 the DRIVERS DOOR Trigger is a TAN (-) and the PASSENGER DOOR Trigger is a TAN/WHITE (-) when connecting to an Alarm System use both and Diode isolate.

NOTE *3 the BCM is attached to the LEFT of the FUSE BOX, Connector 1 is a GREY 26 Pin plug, and Connector 2 is a GREY 22 Pin plug.

NOTE *4 the Resistance value of this Resistor to Disarm can be a Standard 470 or 480 Ohm resistor.

posted_image

posted_image

Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.
Teamrf 
Gold - Posts: 1,039
Gold spacespace
Joined: January 13, 2004
Location: United States
Posted: November 21, 2004 at 4:29 PM / IP Logged  
Also..all of the other doors are tan with a stripe as well. (Ex. Tan/Blk) You have to use ALL of them and diode isolate each one.
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, April 30, 2017 • Copyright © 1999-2017 the12volt.com Donate to the12volt.com Advertising Top of Page
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Donate to the12volt.com
Top
the12volt.com spacer
the12volt.com spacer