2005 Toyota Camry Alarm/Remote Start Wiring
Home /
the12volt's Install Bay /
Vehicle Wiring Information & File Requests / 2005 Toyota Camry Alarm/Remote Start Wiring (
Topic Closed)
Topic Closed)
Members
Search
Register
Login
Posted: January 02, 2005 at 2:27 PM / IP Logged
Posted: January 02, 2005 at 8:52 PM / IP Logged
| 12volts | WHITE/ red (30A), white (5A) | + | ignition harness |
| Starter | BLACK/ white | + | ignition harness |
| Second Starter | BLACK / YELLOW | + | ignition harness |
| Ignition | BLACK/ red | + | ignition harness |
| Second Ignition | BLACK / YELLOW | + | ignition harness |
| Third Ignition | N/A | ||
| Accessory | blue/red | + | ignition harness |
| Second Accessory | N/A | ||
| Keysense | blue | - | ign harn or BECU, top plug, pin 19 |
| Notes: Using the status output to trigger this wire during remote start will disarm the alarm without unlocking the doors.The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. | |||
| Power Lock | blue / YELLOW | - | DKP or bottom of fusebox, 20 pin plg |
| Notes: Meter this wire while turning the key in the driver door key cylinder. | |||
| Power Unlock | blue (double pulse) | - | DKP or BECU, top plug, pin 22 |
| Notes: Meter this wire while turning the key in the driver door key cylinder.The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge.Can also use the passenger door key cylinder unlock wire, which only requires a single pulse. It is blue/white (-) in the BECU, top plug, pin 21. | |||
| Lock Motor | blue/red | 5wi | DKP or bottom of fusebox, 13 pin plg |
| Unlock Motor | blue/black | 5wi | DKP or BECU, bottom plug, pin 11 |
| Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. | |||
| Parking Lights+ | green | + | DKP or bottom of fusebox, 20 pin plg |
| Parking Lights- | red | - | switch or BECU, top plug, pin 8 |
| Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. | |||
| Hazards | lt. GREEN/ black | - | switch or BECU, middle plug, pin 10 |
| Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. | |||
| Turn Signal(L) | GREEN / WHITE | + | turn signal flasher relay in DKP |
| Turn Signal(R) | GREEN/ YELLOW | + | turn signal flasher relay in DKP |
| Reverse Light | RED / black | + | DKP or bottom of fusebox, 20 pin plg |
| Door Trigger | see notes | - | see notes |
| Notes: The LF door is RED / green in the BECU, bottom plug, pin 1. The RF door is RED / green in the BECU, top plug, pin 11. The rear doors are RED / white in the bottom of the fuse box, 20 pin plug, pin 7. Use all three wires and diode isolate each.The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. | |||
| Dome Supervision | GREEN/ red | - | ignition key cylinder light |
| Trunk/Hatch Pin | green | - | DKP or BECU, bottom plug, pin 6 |
| Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. | |||
| Hood Pin | black | - | theft deterrent ECU behind glovebox |
| Trunk/Hatch Release | WHITE/ blue | 5wi | DKP or BECU, bottom plug, pin 12 |
| Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. | |||
| Power Sliding Door | N/A | ||
| Factory Alarm Arm | arms with lock | ||
| Factory Alarm Disarm | disarms with unlock | ||
| Disarm No Unlock | use key sense wire | ||
| Tachometer | BLACK/ orange | ac | ECM behind glovebox |
| Notes: On the 4 cylinder models, it is in the 2nd plug from the top, pin 1. On the 6 cylinder models, it is in the top plug, pin 5.Can also go to any ignition coil or fuel injector and use the wire that is NOT BLACK/ red, WHITE/ red, or WHITE/ black. | |||
| Wait to start | N/A | ||
| Brake Wire | GREEN / WHITE | + | sw or bottom of fusebox, 20 pin plug |
| Parking Brake | RED / white | - | parking brake switch |
| Horn Trigger | GREEN/ black | - | sw or bottom of fusebox, 24 pin plug |
| Memory Seat 1 | N/A | ||
| Memory Seat 2 | N/A | ||
| Memory Seat 3 | N/A | ||
| Immobilizer Bypass Module: | Required: Yes | Type: Transponder | Part #: 556U or 555U |
| Notes: Standard on the LE V6, SE V6, and XLE models. | |||
Posted: January 02, 2005 at 9:42 PM / IP Logged
Sorry, you can NOT post a reply.
This topic is closed.
Printable version
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com 
Wednesday, April 24, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Wednesday, April 24, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
