the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2003 Mazda 6 Remote Start Wiring Diagram


Post ReplyPost New Topic
< Prev Topic Next Topic >
Sick64LBC19st 
Member - Posts: 2
Member spacespace
Joined: September 02, 2004
Location: United States
Posted: August 24, 2005 at 11:37 PM / IP Logged  
12volts      black (40A), BLACK/ yel (30A)       +       ignition harness
Starter      BLACK/ blue       +       ignition harness
Second Starter      N/A            
Ignition      blue       +       ignition harness
Second Ignition      N/A            
Third Ignition      N/A            
Accessory      BLACK/ red       +       ignition harness
Second Accessory      BLACK/ white       +       ignition harness
Keysense      WHITE/ blue       +       ignition harness
Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.
Power Lock      lt. green       -       driver kick or door lock module
Notes: Lock is negative trigger thru a 1.4K ohm resistor. Unlock is a straight negative trigger. MUST use relays.
The door lock control module is located above the passenger kick panel.
Power Unlock      same as power lock wire            
Lock Motor      RED / blue       5wi      driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Unlock Motor      RED / green       5wi      driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Parking Lights+      lt. GREEN/ black       +       driver kick, 14 pin plug
Parking Lights-      RED / white       -       headlight switch
Hazards      blue/orange       -       switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Turn Signal(L)      WHITE/ black       +       turn signal switch
Turn Signal(R)      WHITE/ red       +       turn signal switch
Reverse Light      RED / yellow       +       driver kick, 14 pin plug
Door Trigger      GREEN/ orange       -       driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Dome Supervision      yellow/black       -       driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Trunk/Hatch Pin      brown       -       driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Hood Pin      gray/red       -       pin switch or theft module
Notes: The theft-deterrent control module is located in the center console.
Trunk/Hatch Release      yellow       -       switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Power Sliding Door      N/A            
Factory Alarm Arm      blue       -       driver kick or door lock module
Notes: Arm is negative trigger thru a 1.4K ohm resistor. Disarm is a straight negative trigger. MUST use relays.
The door lock control module is located above the passenger kick panel.
Factory Alarm Disarm      same as factory alarm arm wire           
Disarm No Unlock      use key sense wire            
Tachometer      NOT blk/wht or grn/stripe       ac       any ignition coil or coil pack
Notes: On the 4 cyl models use the wire that is NOT BLACK/ white. On the 6 cyl models use the wire that is NOT GREEN/ stripe.
Wait to start      N/A            
Brake Wire      green       +       brake pedal switch
Parking Brake      brown       -       parking brake switch
Horn Trigger      PURPLE / white       -       switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Memory Seat 1      N/A            
Memory Seat 2      N/A            
Memory Seat 3      N/A            
Interface Module:      Category:
Immobilizer Bypass      Required:
Yes      Type:
Transponder
Part #: 556UW
Alternate Part1 #: 555U
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes:
Interface Module:      Category:
Door Lock Interface      Required:
Yes      Type:
Multiplex
Part #: 456LW
Notes:12volts      black (40A), BLACK/ yel (30A)       +       ignition harness
I hope this helps...
                   
                    - Mark -
Why keep it stock when you can CUSTOMIZE IT!!!

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Monday, March 18, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer