the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

04 Buick Regal remote start wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
detroitbass 
Member - Posts: 19
Member spacespace
Joined: August 09, 2005
Posted: October 28, 2005 at 4:44 PM / IP Logged  
I need a wiring diagram for a 2004 Buick Regal please. I am going to be installing a remote starter.
pss5075104 
Copper - Posts: 144
Copper spacespace
Joined: February 09, 2005
Location: United States
Posted: October 28, 2005 at 6:07 PM / IP Logged  
12volts red (x2)  +  ignition harness
Starter yellow  +  ignition harness
Second Starter N/A    
Ignition pink  +  ignition harness
Second Ignition white to dk. green  +  ignition harness
Third Ignition N/A    
Accessory orange  +  ignition harness
Second Accessory brown  +  ignition harness
Keysense lt. green  -  ign harn or BCM, purple plug, pin A1
Notes: The BCM (Body Control Module) is to the left of the steering column.
Power Lock RED / black  -  BCM, purple plug, pin B6
Notes: The BCM (Body Control Module) is to the left of the steering column.
Power Unlock ORANGE / black  -  BCM, purple plug, pin A6
Notes: The BCM (Body Control Module) is to the left of the steering column.
Lock Motor gray  5wi BCM, clear plug, pin G
Notes: The BCM (Body Control Module) is to the left of the steering column.
Unlock Motor tan  5wi BCM, clear plug, pin E
Notes: The BCM (Body Control Module) is to the left of the steering column.
Parking Lights+ lt. blue (larger of 2)  +  headlight switch
Parking Lights- gray/black  -  BCM, lt. blue plug, pin A4
Notes: The BCM (Body Control Module) is to the left of the steering column.
Hazards same as turn signals    
Turn Signal(L) lt. blue (F), yellow (R)  +  steering column
Turn Signal(R) dk. blue (F), dk. green (R)  +  steering column
Reverse Light dk. blue  -  BCM, lt. blue plug, pin A8
Notes: The BCM (Body Control Module) is to the left of the steering column.
Door Trigger dk. blue/white  -  BCM, purple plug, pin A5
Notes: The BCM (Body Control Module) is to the left of the steering column.
Dome Supervision use door trigger wire    
Trunk/Hatch Pin ORANGE / black  -  BCM, lt. blue plug, pin B4
Notes: The BCM (Body Control Module) is to the left of the steering column.
Hood Pin N/A    
Trunk/Hatch Release white  -  BCM, purple plug, pin A7
Notes: The BCM (Body Control Module) is to the left of the steering column.
Power Sliding Door N/A    
Factory Alarm Arm N/A    
Factory Alarm Disarm N/A    
Disarm No Unlock N/A    
Tachometer PURPLE / white or white  ac  ignition control module
Notes: The ignition control module is on the top right front of the engine.
Wait to start N/A    
Brake Wire white  +  brake pedal switch or column
Parking Brake lt. blue  -  BCM, purple plug, pin A2
Notes: The BCM (Body Control Module) is to the left of the steering column.
Horn Trigger black  -  column or BCM, lt. blue plug, pin A5
Notes: The BCM (Body Control Module) is to the left of the steering column.
Memory Seat 1 N/A    
Memory Seat 2 N/A    
Memory Seat 3 N/A    
04 Buick Regal remote start wiring -- posted image.
Interface Module:Category:
Immobilizer Bypass
Required:
Yes
Type:
VATS
Part #: 652T resistor pack
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: See DirectFax document 1049 for interface information.
04 Buick Regal remote start wiring -- posted image.
D
MECP First Class Certified Installer.
Nothing is impossable, it's just more expensive.
detroitbass 
Member - Posts: 19
Member spacespace
Joined: August 09, 2005
Posted: October 29, 2005 at 10:15 AM / IP Logged  
Thank you. Is this an easy install? Any tips or tricks to help me through it?
detroitbass 
Member - Posts: 19
Member spacespace
Joined: August 09, 2005
Posted: October 29, 2005 at 11:16 AM / IP Logged  
Also, I bought the DEI Immobilizer Byass that was suggested. Any help in installing this?
pss5075104 
Copper - Posts: 144
Copper spacespace
Joined: February 09, 2005
Location: United States
Posted: November 01, 2005 at 4:10 PM / IP Logged  
the install does not look to bad to me but i do them all the time.
D
MECP First Class Certified Installer.
Nothing is impossable, it's just more expensive.
detroitbass 
Member - Posts: 19
Member spacespace
Joined: August 09, 2005
Posted: November 02, 2005 at 6:06 PM / IP Logged  
Ok I got the 562T bypass system. It has 5 wires, red, black, orange, yellow, and brown. I know the red and black are hot and ground, but what are the yellow, orange, and brown wires for exactly?
detroitbass 
Member - Posts: 19
Member spacespace
Joined: August 09, 2005
Posted: November 02, 2005 at 6:10 PM / IP Logged  
And which one do I wire the resistor in?
detroitbass 
Member - Posts: 19
Member spacespace
Joined: August 09, 2005
Posted: November 03, 2005 at 11:18 AM / IP Logged  
I mean the 652t, not 562t

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer