2006 nissan armada, drl

Home / the12volt's Install Bay / Lights, Neon, LEDs, HIDs / 2006 nissan armada, drl (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

ramiroggenbu

Member - Posts: 9

Joined: October 28, 2005

Location: United States

Posted: October 27, 2006 at 1:52 AM / IP Logged

I am looking for a wiring diagram for a 2006 nissan armada to install a remote start. Any help would be greatly apperciated.

Thanks

Mike R.

KarTuneMan

Platinum - Posts: 7,056

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: December 14, 2004

Location: Isle Of Man

Posted: October 27, 2006 at 8:49 AM / IP Logged

Wire/Function

Colour

Location/Description

Polarity

PASSIVE ANTI-THEFT

YES

TRANSPONDER

SEE NOTES

12 VOLTS

Dk.green

Ignition switch harness

IGNITION

BLACK/ red

Ignition switch harness

ACCESSORY

Red

Ignition switch harness

ACCESSORY 2

Violet

Ignition switch harness

STARTER

Brown

Ignition switch harness

STARTER 2

Lt.green

Ignition switch harness

KEY SENSE

RED / blue

Ignition switch harness

TACH SIGNAL

Not Black or WHITE/ blue

At any of the ignition coils on the engine

FUEL INJECTOR

Opposite from White

At any injector on engine

LOCK

Blue

At module inside driver's door

UNLOCK

Red (double pulse)

At module inside driver's door

DOORPIN

SEE NOTES

Lt.blue (driver's door), RED / blue (front right), RED / yellow (rear left) and RED / white (rear right). All 4 wires are (-) and found at the BCM on the right side of the steering column.

TRUNK PIN

RED / black

At BCM on right side of steering column

The rear window is a GRAY wire in the same location.

TRUNK RELEASE

Blue/white

At release switch in dash

FACTORY ARM

Arms with lock wire

FACTORY DISARM

Disarms with unlock wire

BRAKESWITCH

RED / black

24-pin White plug in driver's kickpanel

PARKLIGHTS

RED / blue

24-pin White plug in driver's kickpanel

HAND BRAKE

Green

At switch above handbrake lever

HORN

RED / white

At steering column

VSS WIRE

WHITE/ red

Behind instrument panel

Available Notes

Vehicle Notes

PLEASE NOTE: This vehicle is equipped with an IMMOBILIZER passive antri-theft system. Please refer to the appropriate security diagram before any remote start installation. IMPORTANT: If the lightswitch has an AUTO position, you will need to pulse the doorpin wire on a remote start shutdown to deactivate the light delay. The light will stay on for another 40 seconds.

sdarby

Member - Posts: 1

Joined: November 01, 2006

Location: United States

Posted: November 01, 2006 at 7:11 PM / IP Logged

do you have the wiring for the radio for the 2006 armada? I am trying to hook up and aftermarket amp and satilite

rookie

xplicitmoods99

Member - Posts: 6

Joined: November 06, 2006

Location: United States

Posted: November 09, 2006 at 11:32 AM / IP Logged

Which wire is used to disarm the factory alarm to allow the remote start to work?

The Great One

Search for other posts by xplicitmoods99

mikvot

Gold - Posts: 1,043

Joined: December 19, 2006

Location: Missouri, United States

Posted: December 30, 2006 at 10:31 PM / IP Logged

red, in drivers door at switch

mmss2302

Member - Posts: 1

Joined: February 01, 2007

Location: United States

Posted: February 01, 2007 at 2:37 PM / IP Logged

I AM LOOKING FOR THE POWER WINDOW WIRES INSIDE THE VEHICLE SO I CAN PUT A WINDOW MODULE IN, ANY HELP WOULD BE APPRECIATED!!!

lets get wired

mikvot

Gold - Posts: 1,043

Joined: December 19, 2006

Location: Missouri, United States

Posted: February 01, 2007 at 8:09 PM / IP Logged

LF Window up/dn GREEN/ red - GREEN / WHITE A LF window switch in door

RF Window up/dn blue - green A RF window switch in door

LR Window up/dn RED / black - RED / yellow A driver kick, door harness

RR Window up/dn blue - red A driver kick, door harness

legcne

Member - Posts: 1

Joined: February 14, 2007

Posted: February 14, 2007 at 8:38 PM / IP Logged

I want to hook some DRLs that are switched on with the ignition. I connected a relay wire to the red wire of my 2006 Armada (my voltmeter indicated that it had 12vdc that was switched) . When I turned on the ignition to fire them up, the headlights came on, albeit dimly. After a few minutes they dimmed but something near the passenger side firewall in the engine compartment started clicking and the park lights started blinking at the same rate. Now the headlights will not activate and the engine will not start. Has anyone a bright idea of what kind of a dimwit error I made??

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2006 nissan armada, drl

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.