When performing a diagnosis on a battery that has gone dead overnight, an installer may notice that the vehicle has approximately 4.1 amp draw on the system. The draw may be steady or may drop to a few millivolts then go back up to 4.1 amps.
This may happen if you install an overhead monitor or other accessory and connect to the orange constant positive power wire in the vehicle’s courtesy light circuit. This will cause the power timer in the BCM to keep re-starting. The BCM will awake and draw 4.1 amps.
This orange wire circuit exits the BCM at pin 1 of connector 2. Cut the wire to test this condition.
Feed your aftermarket accessory in a different fashion.
___________________________________ Prepare your future. It wasn't the lack of stones that killed the stone age.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum