12volts	pink/black	+	ignition harness
Starter	yellow	+	ignition harness
Second Starter	N/A
Ignition	blue	+	ignition harness
Second Ignition
Third Ignition
Accessory	black/orange	+	ignition harness
Second Accessory	black/white	+	ignition harness
Keysense
Power Lock	lt. green	-	driver kick, door harness
Power Unlock	same wire as power lock
Lock Motor	orange/black	5wi	driver kick, door harness
Unlock Motor	pink/black	5wi	driver kick, door harness
Parking Lights+	black/yellow	+	steering column
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	yellow	-	driver kick panel
Dome Supervision	use door trigger
Trunk/Hatch Pin	tan/black	-	light in trunk
Hood Pin
Trunk/Hatch Release	lt. green/black	5wi	keyless entry module
Power Sliding Door	N/A
Factory Alarm Arm	arms with lock
Factory Alarm Disarm	disarms with unlock
Disarm No Unlock	see factory alarm disarm
Tachometer	black/gray	ac	ignition coil
Wait to start	N/A
Brake Wire	white/tan	+	brake pedal switch
Parking Brake
Horn Trigger	black/red	-	steering column

Lock requires a negative trigger thru a 1K (1000) ohm resistor. Unlock requires a negative trigger thru a 250 ohm resistor. MUST use relays.

If the vehicle has factory alarm, arm/lock is negative trigger thru a 2.7K (2700) ohm resistor, and disarm/unlock is negative trigger thru a 7.5K (7500) ohm resistor, use double pulse for unlock.

 To avoid the dome light delay use tan (-) in the driver kick for the driver door and blue/orange (-) in the passenger kick for the passenger door(s). Use both wires and diode isolate each.

The keyless entry module is located in the center top of the dash. Remove the dash top to access.