I need the wiring for a 2010 Kia Soul. Doing a remote start alarm. Also if there is a bypass module suggestion I would appreciate it. I would like to use the Compustar Blade if it will work.

Thanks

KIA SOUL   2010 -                      Info from Bulldog Security
 
 PART                                      COLOR                                     LOCATION
 12 VOLT CONSTANT           WHITE (+), 40 AMP                   @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 5 
 STARTER                               BLUE (+)                                    @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 1 
 STARTER 2                           N/A  
 IGNITION 1                           PINK (+)                                       @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 6
 IGNITION 2                           N/A    
 IGNITION 3                           N/A    
 ACCESSORY/HEATER BLOWER 1  WHITE (+), NOTE #2           @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 3 
 ACCESSORY/HEATER BLOWER 2  YELLOW (+)                          @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 4 
 KEYSENSE                          N/A    
 PARKING LIGHTS ( - )       PINK (-)                                                    @ HEADLIGHT SWITCH, (WHITE, 13-PIN PLUG), PIN 1 
 PARKING LIGHTS ( + )     GREEN/BLACK(+)(Left) and 
                                               YELLOW/BLACK(+)(Right), use both!!  @ DASH FUSE BOX, (REAR BLUE, 22-PIN PLUG(I), PINS 17 and 16 
 POWER LOCK                   BROWN (-), TYPE B                              in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 10 
 POWER UNLOCK               GREEN (-), TYPE B, NOTE #3          in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 18 
 DOOR TRIGGER                GREEN (-)                                              in PASSENGER KICK PNEL, (WHITE, 26-PIN PLUG), PIN 16 
 DOMELIGHT SUPERVISION      BLUE (-)                                       in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 14 
 TRUNK RELEASE              PINK (-), NOTE #4                                in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 1 
 SLIDING POWER DOOR         N/A    
 HORN                                     GRAY (-)                                              Above DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 29 
 TACH                                      GREEN, (AC)                                      Above DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 17 
 WAIT TO START LIGHT        N/A    
 BRAKE                                   RED/ORANGE (+)                              Above DRIVERS KICK PANEL, (WHITE, 14-PIN PLUG), PIN 7 
 FACTORY ALARM DISARM       GRAY (-) and YELLOW (-) NOTE #5     in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PINS 13 and 23 
 ANTI-THEFT  KIA'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1   @ IGNITION SWITCH TUMBLER 

 EXTRA INFORMATION
 NOTE #1: KIA'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module
 for REMOTE STARTING
 NOTE #2: this wire may need to be RELAY ISOLATED to prevent STARTER GRIND upon KEY take over.
 NOTE #3: to UNLOCK just the DRIVERS DOOR, use the BROWN (-), at the DASH FUSE BOX,
 (REAR WHITE, 20-PIN PLUG(D), PIN 1
 NOTE #4: TEST this wire while Opening the TAILGATE with the Handle on the REAR of the Vehicle.
 NOTE #5: to DISARM, use the GRAY (-) and the YELLOW (-) use both wires, and DIODE ISOLATE will
 Require a Double Pulse. TEST these wires while turning the KEY in the Drivers Door. 
___________________________________
Soldering is fun!

As for bypass modules, only Fortin lists their PATS-KIA-1 bypass for the Soul and that would require a dealer scan tool to program.  Looks like it's a key in the box...