Joined: July 21, 2004 Location: United States Posts: 21
Posted: May 28, 2010 at 5:47 PM - IP Logged
I installed an Audiovox CCS-100 cruise on a street rod several years ago and I also installed the stock appearing wiper stalk rather than the dash control on/off, set/resume switch. The unit has worked OK til recently. It took an abnormal amount of pressure on the set button and the only way it would work for a while was when I used the resume slider switch on the wiper stalk. Then it stopped working altogether. I went through with a volt/ohm meter and everthing checks out. I then reinstalled the dash switch and disconnected the wiring from the wiper stalk so now I can at least see that there is power to the unit. I then checked the vacuum hoses and the magnet and speed sensor all to no avail. The unit does turn on and off but will not engage. What else can I check? Any suggestions would be appreciated.
Joined: July 21, 2004 Location: United States Posts: 21
Posted: May 29, 2010 at 10:45 AM - IP Logged
Thought I checked ALL of the wiring but I was wrong. Checked the four post only did not have power on the brown wire at the unit under the car. Broken wire!! All fixed now thanks!!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum