|
|
the12volt's install bay
Mobile Electronics Forums |
|
Welcome Guest :) |
|
|
 Topic: 2011 nissan quest sl remote start
|
  |
|
| Author |
|
|
nixapatfan
Joined: November 27, 2002
Location:
United States
Posts: 7 |
| Posted: November 17, 2011 at 8:43 AM - IP Logged |
|
|
Anyone have wiring diagrams for a 2011 Nissan Quest SL? I want to install a remote start system on it. I'd also like info on bypassing the immobilizer.
I'm looking to install the Audiovox AS9234 and a compatible immobilizer bypass with data link(Flashlogic - but Quest not listed compatible yet) so I can use the factory key fobs and keep installation clean.
If anyone has a better solutoin for a system like this, I'm open to suggestions. |
|
| Back to Top |
 |
|
|
Hi Guest
Not a member?
Register
Already
a member?
Sign In
|
|
|
|
ropuma
Joined: February 16, 2010
Location:
Illinois,
United States
Posts: 93 |
| Posted: January 14, 2012 at 11:19 AM - IP Logged |
|
|
(+) BCM, PIN 15 OF WHITE 15 PIN PLUG
Ignition 1 GRAY (+) BCM, PIN 29 OF WHITE 40 PIN PLUG
Starter 1 VIOLET (PUSHBUTTON START) (-) AT IGNITION SWITCH OR BCM, PIN 6 OF WHITE 40 PIN PLUG
Domelight Super RED OR WHITE (-) BCM, PIN 7 OR 8 OF WHITE 15 PIN PLUG
LF Latch GREEN (-) BCM, PIN 7 OF BLACK 15 PIN PLUG
RF Latch LT BLUE (-) BCM, PIN 5 OF BLACK 15 PIN PLUG
LR Latch ORANGE (-) BCM, PIN 8 OF BLACK 15 PIN PLUG
RR Latch RED (-) BCM, PIN 6 OF BLACK 15 PIN PLUG
Trunk Trigger PINK (-) BCM, PIN 3 OF BLACK 15 PIN PLUG
Alarm Disarm WHITE (KEY CYLINDER IN DR. DOOR) (-) BCM, PIN 7 OF 40 PIN BLACK PLUG (WITHOUT POWER SLIDING DOOR) DOUBLE PULSE
Alarm Arm YELLOW (KEY CYLINDER IN DR. DOOR) (-) BCM, PIN 8 OF 40 PIN BLACK PLUG (WITHOUT POWER SLIDING DOOR)
Parking Lights RED/BLUE (+) AT FUSE BOX, PIN 8 OF WHITE 10 PIN PLUG
Low Crr Pk Lights AUTO LAMPS: WHITE (-) BCM, PIN 33 OF 40 PIN BLACK PLUG
Note: makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
|
|
| Back to Top |
|
|
|
shortcircuit161
Joined: August 29, 2010
Location:
Pennsylvania,
United States
Posts: 100 |
| Posted: January 14, 2012 at 11:42 AM - IP Logged |
|
|
Not sure if this is the PTS or Standard Key model but both DEI (Xpresskit) and Fortin show bypass modules for this vehicle.
Check
-ifar.ca (Fortin)
-xpresskit.com (DEI)
Idatalink (maker of the Flashlogic units) don't have that model listed.
DEI shows the DB-ALL will work for it.
Fortin shows the EVO-CAN or EVO-ALL will work for it.
Either module will have to be flashed to the correct firmware.
I believe the Fortin bypass will work with datalink on that model of remote starter. But any of the bypasses will work well if connected Wire2Wire. |
|
| Back to Top |
|
|
|
|
If you wish to post a reply to this topic you must first login
If you are not already registered you must first register
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
| |
Member List
Search
Register
Login
