|
|
the12volt's install bay
Mobile Electronics Forums |
|
Welcome Guest :) |
|
|
| Author |
|
|
daytonboi
Joined: August 16, 2010
Location:
Ohio,
United States
Posts: 12 |
| Posted: December 03, 2011 at 6:49 PM - IP Logged |
|
|
I have a 98 Chevy Astro van. At the present point in time I have disabled the low beam DRLs, because I am running HIDs. What I want to do is wire up the high beams at a reduced intensity. While this would normally be an easy task, only having to find a circuit that is live only when the key is in the run position. However, I also have the headlights wired in a 4-HI setup so when the high beams are on, all of the headlights are on.
The 4-Hi is a single relay, 86-ground, 30-12v, 85-high, 87-low. Also there are caps on the low beam side just ahead of the ballast to store power so that i can switch from low to 4-HI without the low beams going out.
Any help would be appreciated.
___________________________________
1998 Chevrolet Astro AWD |
|
| Back to Top |
 |
|
|
Hi Guest
Not a member?
Register
Already
a member?
Sign In
|
|
|
|
|
If you wish to post a reply to this topic you must first login
If you are not already registered you must first register
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
| |
Member List
Search
Register
Login
Topic: high beam drl
