|
|
the12volt's install bay
Mobile Electronics Forums |
|
Welcome Guest :) |
|
|
 Topic: relay for auto open?
|
  |
|
| Author |
|
|
riveradel
Joined: December 28, 2011
Location:
Florida,
United States
Posts: 6 |
| Posted: December 28, 2011 at 5:07 PM - IP Logged |
|
|
| has anybody ever done the relay for auto-open,follow the diagram but it does not work. |
|
| Back to Top |
 |
|
|
Hi Guest
Not a member?
Register
Already
a member?
Sign In
|
|
|
|
howie ll
Joined: January 09, 2007
Location:
United Kingdom
Posts: 9,717 |
| Posted: December 28, 2011 at 5:26 PM - IP Logged |
|
|
What do you mean, auto unlock perhaps?
___________________________________
Amateurs assume, don't test and have problems; pros test first.
Read the installation manual, do a search here for your vehicle wiring. |
|
| Back to Top |
|
|
|
howie ll
Joined: January 09, 2007
Location:
United Kingdom
Posts: 9,717 |
| Posted: December 28, 2011 at 5:31 PM - IP Logged |
|
|
Do you mean auto unlock perhaps and please read again the last few words "depending on vehicle application".
Please elaborate and explain why it doesn't work.
___________________________________
Amateurs assume, don't test and have problems; pros test first.
Read the installation manual, do a search here for your vehicle wiring. |
|
| Back to Top |
|
|
|
riveradel
Joined: December 28, 2011
Location:
Florida,
United States
Posts: 6 |
| Posted: December 28, 2011 at 5:35 PM - IP Logged |
|
|
| Yes that is what i meant.the schematic i was referring to is the one on this site.did auto lock by using the ignition wire to the starter it works fine but could'n figure out how to do auto-unlock. |
|
| Back to Top |
|
|
|
howie ll
Joined: January 09, 2007
Location:
United Kingdom
Posts: 9,717 |
| Posted: December 28, 2011 at 5:38 PM - IP Logged |
|
|
What vehicle? Make, model, year?
___________________________________
Amateurs assume, don't test and have problems; pros test first.
Read the installation manual, do a search here for your vehicle wiring. |
|
| Back to Top |
|
|
|
riveradel
Joined: December 28, 2011
Location:
Florida,
United States
Posts: 6 |
| Posted: December 28, 2011 at 5:42 PM - IP Logged |
|
|
| connected the relay as per the diagram with the capacitor and resistor but when i connect the power it doesn't activate the relay,unless i connect the wire on pin 86 to ground and not the ignition 12v wire. |
|
| Back to Top |
|
|
|
riveradel
Joined: December 28, 2011
Location:
Florida,
United States
Posts: 6 |
| Posted: December 28, 2011 at 5:44 PM - IP Logged |
|
|
| 2002 s 10 with aftermarket door locks. |
|
| Back to Top |
|
|
|
howie ll
Joined: January 09, 2007
Location:
United Kingdom
Posts: 9,717 |
| Posted: December 28, 2011 at 5:54 PM - IP Logged |
|
|
Then the terminal at 86 is still seeing pos, you have to make sure it's seeing a neg, check the diode and capacitor (condensor) polarity.
___________________________________
Amateurs assume, don't test and have problems; pros test first.
Read the installation manual, do a search here for your vehicle wiring. |
|
| Back to Top |
|
|
|
riveradel
Joined: December 28, 2011
Location:
Florida,
United States
Posts: 6 |
| Posted: December 28, 2011 at 5:57 PM - IP Logged |
|
|
will do that and post later.
thank's for your help. |
|
| Back to Top |
|
|
|
howie ll
Joined: January 09, 2007
Location:
United Kingdom
Posts: 9,717 |
| Posted: December 28, 2011 at 6:11 PM - IP Logged |
|
|
Purple ignition wire goes to ground, when ignition is switched off.
The first diode, make sure the band is towards the ignition conditions it to a definite negative.
This is constant so the cap and resistor bleed it off to 0.8 seconds.
The caps + mark should go to the green relay side.
No more comments for 8 hours please, it's 00:11 am here.
___________________________________
Amateurs assume, don't test and have problems; pros test first.
Read the installation manual, do a search here for your vehicle wiring. |
|
| Back to Top |
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
| |
Member List
Search
Register
Login
