|
|
the12volt's install bay
Mobile Electronics Forums |
|
Welcome Guest :) |
|
|
 Topic: 06 hondal civic rs issues viper db all
|
  |
|
| Author |
|
|
sam_mrofcza
Joined: January 09, 2012
Location:
Illinois,
United States
Posts: 18 |
| Posted: January 28, 2012 at 2:37 PM - IP Logged |
|
|
| Ok so....i got fed up looking for this wire...i swear this car has been a nightmare. I took the drivers door apart and found it there. Hooked it up and everything seems to working fine...although now the doors dont work with the RS remote....but to honest at this point i could careless and i'll tell customer they need to use the key in the door (i'll blame it on honda). Im going to let it sit for a min and try it a few more times, just to make sure its working properly. |
|
| Back to Top |
 |
|
|
Hi Guest
Not a member?
Register
Already
a member?
Sign In
|
|
|
|
sam_mrofcza
Joined: January 09, 2012
Location:
Illinois,
United States
Posts: 18 |
| Posted: January 28, 2012 at 4:39 PM - IP Logged |
|
|
| I have to have an issue with the control unit and/or attena. Its like the signal is just not getting through. I get a negative tone on the remote, intermittently of course, and nothign happens. This has also happen when i was trying to set up system features...i can get into the menu fine but then when i hit the button on the remote i get the negative tone and nothing happens. Thoughts? |
|
| Back to Top |
|
|
|
tedmond
Joined: January 06, 2007
Location:
Ontario,
Canada
Posts: 3,843 |
| Posted: January 28, 2012 at 7:40 PM - IP Logged |
|
|
the door locks have to be hard wired. the dball has options for wires into the bypass, and analog signals out for the door locks.
should read the manual thoroughly before installing.
___________________________________
Ted
P2W901SS
Compustar Pro Dealer
"If your girlfriend yells at the top of her lungs, is that SQ or SPL?" |
|
| Back to Top |
|
|
|
kop1
Joined: January 27, 2012
Location:
United Kingdom
Posts: 2 |
| Posted: January 29, 2012 at 4:59 PM - IP Logged |
|
|
| I have worked on quite a few civics in the uk and when using the dball you need to hardwire the negative cdl wires at the plug coming in from the drivers door as it enters the car. |
|
| Back to Top |
|
|
|
tedmond
Joined: January 06, 2007
Location:
Ontario,
Canada
Posts: 3,843 |
| Posted: January 29, 2012 at 6:35 PM - IP Logged |
|
|
kop1 is right. you got to do this for all 06+ civics
___________________________________
Ted
P2W901SS
Compustar Pro Dealer
"If your girlfriend yells at the top of her lungs, is that SQ or SPL?" |
|
| Back to Top |
|
|
|
sam_mrofcza
Joined: January 09, 2012
Location:
Illinois,
United States
Posts: 18 |
| Posted: January 30, 2012 at 1:01 PM - IP Logged |
|
|
The door locks were hard wired from the start...i had to add the disarm wire from the viper box cause for some reason the dball was not taking care of that.
So pretty much the only thing i am using the dball for now is a bypass, everything else is wired. For now it seems to be working fine but im not ruling out and issues with either the control unit, or the antenna itself. Time will tell.
Thanks for all your helps guys. |
|
| Back to Top |
|
|
|
sam_mrofcza
Joined: January 09, 2012
Location:
Illinois,
United States
Posts: 18 |
| Posted: February 01, 2012 at 11:21 AM - IP Logged |
|
|
Well i have new viper unit on the way. The current system is still in the customers car and she says its batting about 500. That is 50% of the time when you hit the button it starts up no problem. The other 50% you get a negative tone from the the remote and the car does not start....if you wait a few sec and hit the button again it fires right up. I am hoping that a new control unit and antenna will fix this issue
Thoughts???
Thank you |
|
| Back to Top |
|
|
|
tedmond
Joined: January 06, 2007
Location:
Ontario,
Canada
Posts: 3,843 |
| Posted: February 01, 2012 at 12:41 PM - IP Logged |
|
|
i would rip it all out, then install from scratch. its easier in most cases to find your mistakes. unless you're very good with diagnosing.
___________________________________
Ted
P2W901SS
Compustar Pro Dealer
"If your girlfriend yells at the top of her lungs, is that SQ or SPL?" |
|
| Back to Top |
|
|
|
offroadzj
Joined: June 03, 2005
Location:
New York,
United States
Posts: 1,240 |
| Posted: February 01, 2012 at 1:21 PM - IP Logged |
|
|
Before you replace the entire unit I would just replace the antenna, relearn the remotes, and try again. It very well could be a broken antenna wire or bad antenna. Did you inspect all of the wires on the antenna to make sure none were damaged?
___________________________________
Kenny
Former Installation Manager
Circuit City Roadshop
Store #3160
Albany, NY 12205 |
|
| Back to Top |
|
|
|
sam_mrofcza
Joined: January 09, 2012
Location:
Illinois,
United States
Posts: 18 |
| Posted: February 01, 2012 at 1:23 PM - IP Logged |
|
|
offroadzj wrote:
| Before you replace the entire unit I would just replace the antenna, relearn the remotes, and try again. It very well could be a broken antenna wire or bad antenna. Did you inspect all of the wires on the antenna to make sure none were damaged? |
|
|
Yes i did...I completely removed the antenna cable, visually inspected and ohmed the individual wires.
|
|
| Back to Top |
|
|
|
|
If you wish to post a reply to this topic you must first login
If you are not already registered you must first register
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
| |
Member List
Search
Register
Login
