the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers, Enthusiasts, and Do-It-Yourselfers since 1999 Relay Diagrams - Quick Reference
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers
the12volt.com - Free Technical Information for Mobile Electronics Installers
BasicsCar AudioCar SecurityCruise ControlsDiodesDoor LocksOhm's LawPassive CrossoversRelaysResistorsSubwoofer Enclosures Search
the12volt.com - Free Technical Information for Mobile Electronics Installers
the12volt.com - Free Technical Information for Mobile Electronics Installers
the12volt.com - Free Technical Information for Mobile Electronics Installers
Application GuidesCalculators, Charts, DiagramsDownloads/ManualsFind InstallersForumsGlossarySubwoofer WiringToolsVehicle Wiring Recent Topics
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
 

Diodes
Glossary of Terms
Ohm's Law
Relays
Resistors
Tools and Equipment
Wire Sizes
Introduction
Metra Application Guides
Parallel & Series Calcs
Passive Crossovers
Port Length Calculators
Subwoofer Box Calculators
Subwoofer Enclosure Types
Subwoofer Wiring Options
Thiele - Small Parameters
Miscellaneous
Relay Diagrams
Vehicle Wiring Database
Introduction
Alarm Accessories
Alarm Modules
Alarm Sensors
Basic Connections
Illuminated Entry
Light Flash
Power Door Locks
Starter Interrupts
Pictorials
Relay Diagrams
Vehicle Wiring Database
Introduction
Electrical Connections
Mechanical Connections
Servo Settings
VSS and Tach Info
Vehicle Wiring Databse
All Forums
Buy & Sell Equipment
Car Audio
Car Audio Hot Topics
Car Security & Convenience
Car Security Hot Topics
Car Security Pictorials
Cellular & Communications
Cruise Controls
Employment
Fiberglass & Fabrication
General Discussion
Lights, Neon, LEDs, HIDs
Miscellaneous
Mobile Video & Navigation
Motorcycle Electronics
Music, Favorite Songs
Relays
Rides & Systems Gallery
Vehicle Information
Recent Forum Topics
Forum Help & How To
Forum & Site Notices
Books & DVDs
Calculators
Charts
Diagrams
Downloads - Manuals
Find an Installer
Forums - Q&A
Glossary of Terms
Insurance for Car Stereos
Links
Mobile Tech News
Relay Diagrams
The Application Guide
Vehicle Wiring Database
About the12volt
Hurricane Katrina
Link to Us
Support Us
TopGearAutosport.com
GPS Vehicle Tracking

 
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999

the12volt's install bay
Mobile Electronics Forums

Welcome Guest :)
Display List of Forum MembersMember List  Forum SearchSearch  RegisterRegister  LoginLogin
Custom Search
the12volt`s installbay - Mobile Electronics Forums the12volt's install bay / Car Security and Convenience

Subject Topic: ’05 altima remote start issue

Post ReplyPost New Topic
the12volt's install bay
Author
Message << Prev Page    << Prev Topic  |  Next Topic >>
tedmond
Gold
Gold

Joined: January 06, 2007
Location:
Ontario,
Canada
Posts: 3,843
Posted: January 31, 2012 at 9:30 PM - IP Logged
Link to Post  Post Reply Quote tedmond

your settings should be

1. Door Lock - whatever of the 2 work
2. Parking lights - Off (there is a delay which you dont want anyways)
3. OEM Alarm - OEM Enable

the dball sends factory data codes which mimic the factory alarm. if you have this feature off, when the factory alarm arms those "codes" are not understood by the keyless entry module.

oem alarm enabled wont set your factory alarm off. Only the premium version came with a factory alarm anyways. the keyless entry module still uses those exact codes. change the settings and post your results

i will be using fortin/idata combinations only now.


___________________________________
Ted
P2W901SS
Compustar Pro Dealer

"If your girlfriend yells at the top of her lungs, is that SQ or SPL?"
Back to Top Search for other posts by tedmond
Hi Guest
Not a member?
Register

Already a member?
Sign In  
offroadzj
Standard Member
Standard Member
This member has made a donation to the12volt.com. Click here for more info.

Joined: June 03, 2005
Location:
New York,
United States
Posts: 1,240
Posted: February 01, 2012 at 6:19 AM - IP Logged
Link to Post  Post Reply Quote offroadzj

I'm with you Ted. It seems like everybody on here that uses the xpresskits has had issues... haha. I haven't heard many from the idatalink/fortin people.
___________________________________
Kenny
Former Installation Manager
Circuit City Roadshop
Store #3160
Albany, NY 12205
Back to Top Search for other posts by offroadzj
blue5oh
Junior Member
Junior Member

Joined: January 29, 2012
Location:
Illinois,
United States
Posts: 16
Posted: February 02, 2012 at 4:50 PM - IP Logged
Link to Post  Post Reply Quote blue5oh

Okay...I got around to trying the settings on the DB-ALL and no change. I had it set to enable, disable, and no action. All three had the same results. The door locks and trunk would work well for a few minutes, then I would move the car or start it and then nothing again with the Python remote. Factory key fob still works fine. Also, the light on the DB-ALL still lights when the lock/unlock/trunk button is pushed, but no result. As a note, this feature did work flawlessly when it was D2D. Not sure if that helps with troubleshooting. Thanks guys!
Back to Top Search for other posts by blue5oh
tedmond
Gold
Gold

Joined: January 06, 2007
Location:
Ontario,
Canada
Posts: 3,843
Posted: February 02, 2012 at 6:15 PM - IP Logged
Link to Post  Post Reply Quote tedmond

the solution: buy a fortin or idatalink module

you can connect the d2d cable and still have w2w connections. try that and see if your problem stops.
___________________________________
Ted
P2W901SS
Compustar Pro Dealer

"If your girlfriend yells at the top of her lungs, is that SQ or SPL?"
Back to Top Search for other posts by tedmond
blue5oh
Junior Member
Junior Member

Joined: January 29, 2012
Location:
Illinois,
United States
Posts: 16
Posted: February 02, 2012 at 6:45 PM - IP Logged
Link to Post  Post Reply Quote blue5oh

@tedmond...Thanks for all the advice, and I think that your latest solution is the best. Just remove the DB-ALL all together. Which unit would you suggest, the Fortin or the Idatalink? I have no idea about either one of these or which one I need. Again, I apologize for my ignorance when it comes to this stuff. I just don't want another issue like I am having with the Xpresskit. Thanks!
Back to Top Search for other posts by blue5oh
tedmond
Gold
Gold

Joined: January 06, 2007
Location:
Ontario,
Canada
Posts: 3,843
Posted: February 02, 2012 at 9:59 PM - IP Logged
Link to Post  Post Reply Quote tedmond

do as i suggested. reconnect the DBI d2d cable from the unit to the bypass. You can run the d2d in parallel with the w2w, incase some features dont work over data.
___________________________________
Ted
P2W901SS
Compustar Pro Dealer

"If your girlfriend yells at the top of her lungs, is that SQ or SPL?"
Back to Top Search for other posts by tedmond


the12volt`s installbay - Mobile Electronics Forums the12volt's install bay / Car Security and Convenience
<< Prev Page
Page of 4

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

  Post ReplyPost New Topic
Printable version Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum





ohm's law, resistors, relays, and more

the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
Search the12volt.com
Custom Search
Follow the12volt.com: Follow the12volt.com on Facebook Follow the12volt.com on Twitter Follow the12volt.com on Google +
Share, print & email this page:
Wednesday, May 23, 2012 Copyright © 1999-2012 the12volt.com Donate to the12volt.com Privacy Policy Advertising Free Sitemap Generator
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
BasicsCar AudioCar SecurityCruise ControlsDiodesDoor LocksOhm's LawPassive CrossoversRelaysResistorsSubwoofer Enclosures Search
the12volt.com - Free Technical Information for Mobile Electronics Installers
the12volt.com - Free Technical Information for Mobile Electronics Installers
the12volt.com - Free Technical Information for Mobile Electronics Installers
Application GuidesCalculators, Charts, DiagramsDownloads/ManualsFind InstallersForumsGlossarySubwoofer WiringToolsVehicle Wiring Recent Topics
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers, Enthusiasts, and Do-It-Yourselfers since 1999 Donate to the12volt.com
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999
the12volt.com - Free Technical Information for Mobile Electronics Installers since 1999