Joined: January 06, 2007 Location: Ontario, Canada Posts: 3,843
Posted: February 02, 2012 at 12:10 PM - IP Logged
When updating the compustar brain to:
CM5/6X00 With V6.7 VD6
when connecting to the BLADE through web-link 5, under options setting 1-12 you can change the door trigger to NC or NO. This is beneficial for those that install on older ford/mazda often. luckily late models we have the blade-al to take care of triggers for us. No need for resistors/diodes. leave the jumper on negative and diode isolate all 4 triggers.
not sure if a few of you were aware, but I just noticed this today. Usually i use my op500 to change settings after the install.
___________________________________ Ted
P2W901SS
Compustar Pro Dealer
"If your girlfriend yells at the top of her lungs, is that SQ or SPL?"
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum